Filter
Top Products
IV. Connecting the EZ Port to the Essentia amplifier
When the EZ Port is installed in the wall the only part visible
should be the faceplate and a single RJ45 jack. The supplied pre-
terminated network cable can then be plugged into the jack on
the EZ Port and into the network connection on the back of the
Essentia amplifier, Fig. 4. Any CAT5 cable terminated using 568A
or 568B network wiring will suffice should you need a longer
connection.
SYSTEM
DIGITALLINK
PROGRAM
CONNECTTO
NV-E6DX
USENV-SLC1
CABLE
CONNECTTO
NV-E6DEZP
USENV-NC1
CABLE
SYS ON
EXT. MUTE
NETWORK
EZ Port (front)
Essentia Network
Connection
Network Cable
NV-E6D EZ Port
Model NV-E6DEZP
Connect to NV-E6DM
Audio Distribution Amplifier
V. Attaching Audio Source Equipment to the Essentia Amplifier
Each piece of audio source equipment is connected to the
Essentia amplifier with standard stereo RCA cables. Attach the
RCA cable to the corresponding audio output on the source
equipment and to the desired source input on the back of the
Essentia amplifier, Fig. 5.
SOURCELINK
SOURCEINPUTS
ZONE1
ZONE3
ZONE2
CONNECTTO
NV-E6DX
USENV-SLC1
CABLE
12345
6
12345
6
ZONE1
ZONE3
ZONE2
OUTPUT POWER
OUTPUT POWER
OUTPUT POWER
20W/6OHM X2
20W/6OHM X2
20W/6OHM X2
VARIABLE
OUTPUT
VARIABLE
OUTPUT
VARIAB LE
OUTPUT
FIXED
OUTPUT
FIXED
OUTPUT
FIXED
OUTPUT
TIP=L
RING=R
TIP=L
RING=R
TIP=L
RING=R
Source 1
Tuner 1
Audio
Out
VI. Connecting the IR Emitters
IR commands for the source equipment are transferred from the
Essentia amplifier to the source equipment via mini IR mouse
emitters. Six of these are supplied with your Essentia System.
The emitter is plugged into the corresponding source IR output
on the Essentia and then placed over the IR receiver window on
the source component, fig. 6. The IR outputs are individually
routed to sources 1-6 allowing IR commands from the chosen
source to only control that source.
The two SUM outputs will flash any IR command that is sent from
any of the zones. This is used to connect the NuVo T2 Tuner,
which has a single IR direct input to control both tuners to the
Essentia System or an IR blaster designed to flash IR commands
to a variety of components. This is done by plugging a single
mono 1/8” patch cable into the SUM IR output and into the Direct
IR input.
Fig. 4
Fig. 5
Fig. 6
9