Filter
Top Products
Fig. 2: E-Z Port Backside
Page 7
The location of the E-Z Port is mostly determined by where
you locate the E6M amplifier. All Cat-5 cables should be
terminated and routed to this location. Once this is done,
installation of the E-Z Port is easy.
Plug each of the keypad cables into one of fifteen available
jacks on the back of the E-Z Port (Fig. 2). The jacks are
numbered 1-15, although order is not important to the
systems operation.
Once all the Cat-5 cables are plugged into the E-Z Port,
it can then be easily mounted into any commercially
available dual-gang J-box or mud ring.
Once you have installed the E-Z Port, connect it to the E6M
using the supplied 10 ft. Cat-5 cable supplied with the package
(Fig. 3).
Both RJ45 connectors are wired identically with the 568A wiring
scheme, so either end is connected to the E-Z Port, with the
opposite end connecting to the Network Input on the back of
the E6M.
If the supplied network cable is too short or too long, you can
make your own using the 568A wiring scheme outlined in Fig.
1, page 6.
IR EMITTER OUTPUTS
+12V OUTPUT PULSE
123456
SUM
AUDIO OUTPUT
CONNECT TO NV-E6X
NETWORK
CONNECT TO
NV-EZP
DIGITAL OUTPUT
CONNECT TO
NV-E6X
ODD NUMBERED OUTPUTS ARE IDENTICAL (TIED TOGETHER)
EVEN NUMBERED OUTPUTS ARE IDENTICAL (TIED TOGETHER)
Fig. 3: Network Input
E-Z Port Face Plate
NV-NC1 Network Cable
attaches
the E-Z Port to the E6M
II. Installing the E-Z Port Hub
Cat-5 cables from keypads.
III. Connecting the E6M to the E-Z Port