FIGURE 4
PRINTED
CIRCUIT
BOARD
PLASTIC CLIP
GASKET TAB
IW-6 CABLE
RUBBER
GASKET
FIGURE 5
WEEP
SLOTS
MAKE SURE GASKET IS
COMPLETELY AGAINST
OUTSIDE RIM AND
PUSHED INTO
THE GROOVE
RUBBER
GASKET
IMPORTANT – WHEN NUTONE MODEL IW-6R WIRING
IS USED:
CONNECT TO SCREWS
ON PRINTED CIRCUIT
BOARD MARKED:
ORN
BLK
BLK/WHITE
ORN/WHITE
RED
RED/WHITE
BLUE STRIP
MOUNTING
1. Refer to Figure 5. Carefully place excess wire into
mounting frame.
2. Place gasket (furnished) into groove of mounting frame.
The gasket will fit into both side and top grooves. The
bottom of the frame where the weep slots are should not
be filled with the gasket material.
3. Place edge of the outdoor speaker into groove of the
mounting frame. Make sure the speaker and frame fit
together tightly.
4. Secure speaker to frame with two (2) Nº 8 x 2˝ mounting
screws (furnished).
ISA-449
SPEAKER
Product specifications subject to change without notice.
4820 Red Bank Road, Cincinnati, Ohio 45227
Printed in China, Rev. 08/06, Part No. 61428