NuTone ISA-449WH Speaker User Manual


  Open as PDF
of 2
 
READ & SAVE THESE INSTRUCTIONS!
INSTALLATION INSTRUCTIONS
5˝ Outdoor Speaker
MODEL: ISA-449WH
For use with IMA4406, IM4406, IMA4006
& IM4006 Series Radio/Intercom Systems
LOCATION
1. Determine location for the speaker on outside of house –
near patio, on porch, or other desired location.
2. Locate speaker at a convenient operating height –
approximately 4
1
⁄2 feet above ground.
WIRING (FRAME)
1. Refer to Figure 1. Run cable from master station to
outdoor speaker location.
2. Run wiring through the hole in the mounting frame. Wrap
cable around plastic projection under wiring access hole.
MOUNTING (FRAME)
1. Refer to Figure 1. The mounting frame may be mounted
directly to the exterior wall, or to a single-gang outlet box
mounted in the wall.
2. Before attaching the mounting frame to wall, apply a
continuous bead of caulk around the back edge of the
frame.
3. Secure mounting frame to wall with two (2) Nº 6 - 32 x 1
1
⁄
4˝
mounting screws.
WIRING
Refer to Figure 2. Remove plastic clip that holds the rubber
gasket to the printed circuit board.
Refer to Figure 3. As illustrated, connect wires from the
master unit to the six (6) screw terminals. Red wire to the
terminal marked red, red/white wire to the terminal marked
red/white, etc.
Refer to Figure 4. Fold rubber gasket over installed wiring.
Hold gasket tab to printed circuit board by folding tab over
and sliding the removed plastic clip over tab and printed
circuit board.
FIGURE 2
FIGURE 3
GASKET TAB
ISA-449
PRINTED
CIRCUIT
BOARD
PLASTIC
CLIP
RED
RED/WHITE
BLACK
BLACK/WHITE
ORANGE/WHITE
ORANGE
MOUNTING
FRAME
IW-6
CABLE
FIGURE 1
CAULK AROUND
BACK EDGE OF
FRAME