Filter
Top Products
DM905 Blue Dog
- The Leader in DJ Technology
©1999 Numark Industries - 6 - http://www.numark.com
MIXER FEATURES
1
2
3
4
5
6
7
8
10
9
13
11 12
1. Input fader - Controls individual source levels in the
mix.
2. Input toggle switch - Selects which source will be
live to that channel based on what you have connected to
the rear panel input section.
3. Channel Gain Control – Adjusts the pre-fader
volume for cleaner sound.
4. Replaceable Crossfader - Achieves clean segues
between the two input channels. "Hard left" selects
Channel 1. "Hard right" selects Channel 2. With the
crossfader centered, both assigned channels are live. Use
the crossfader for fast and seamless segues from one
selected channel to the other.
Note: The crossfader is user replaceable in case of failure.
Simply unscrew the two large screws which hold it in
place, lift it out and disconnect it’s cable. Re-attach the
new crossfader and screw the mounting plate back onto the
unit - you’re back in business!
5. Mic Input Gain – Adjusts microphone level.
6. Mic Off/On/Talk Over Toggle – Activates
microphone and talk over mode. Talk over lowers channel
volume so the microphone can be clearly heard.
7. LED Meter - Indicates the Master output level.
8. Channel Cue Slider - Used to route channel audio to
your headphones.
9. Headphone Level – Adjusts cue volume.
10. Master Fader - Controls the overall output level.
11. Mic Input – Plug your 1/4” Microphone plug in here.
12. Headphone Input – Plug in the 1/4” plug for your
headphones here.
13. Power Button – turns unit of and on.
REAR PANEL FEATURES
14. Phono Inputs – Plug your turntables in here. When
these connectors are used, your signal is fed directly to the
high-quality RIAA phono pre-amplifiers.
Use this
position only for turntables
. Line level sources will
overload the sensitive phono pre-amps and will cause
distortion.
15. GND - Grounding lug for turntable connection. Always
use this connection when using turntables. (your turntable
cable should have a grounding wire)
16. Line Inputs - Unbalanced RCA jacks for connecting
stereo audio from line level sources such as CD players,
HiFi VCRs, cassette and reel-to-reel tape decks, DAT
machines, laser discs, tuners, even synthesizers or other
mixing consoles.
NOTE:
Plug mono audio sources into both Left and
Right inputs using a "Y" cable connector.
17. Record Outputs - Unbalanced RCA jacks used to send
the output of the program to any connected recording
device.
18. Stereo Main Outputs - Unbalanced RCA connectors
controlled by the Master fader.
19. Power Connector - Plug in power adapter here and
check the voltage level to match your country’s standard.