Filter
Top Products
CDN-34S
- The Leader in DJ Technology
©1999 Numark Industries - 9 - http://www.numark.com
LCD DISPLAY FEATURES
1. PLAY - Active while the unit is actually playing a CD.
2. PAUSE - Active when the unit is paused.
3. CUE - Flashing when the unit is setting a cue point. Lit
continuously when the unit is paused at a cue point.
4. PROGRAM - Used for preprogramming the track order to
be played automatically by the unit. This is a great
function if you need to leave the CD player alone.
5. TIME MODE -
6. (Elapsed) is for showing time as it is taking place.
7. (Remain) shows how much time is left on a particular
track. This function is controlled by the TIME BUTTON (4).
8. SINGLE - Shows when the unit is set to play just one track
at a time. When this is not lit the CD will play continuously
through all tracks. This function is controlled by the
SING/CONT BUTTON (2).
9. PITCH - Is lit when the PITCH BUTTON is active.
10. TIME BAR - Shows either time remaining or elapsed
depending on the setting of the TIME BUTTON (4).
11. PITCH - Shows the percentage change in pitch.
12. TRACK - Shows the track that the unit is playing with.
13. MINUTES - Shows the minutes elapsed or remaining
depending on mode setting.
14. SECONDS - Shows the seconds elapsed or remaining
depending on mode setting.
15. FRAMES - The CD Player breaks down a second into 75
frames for accurate cueing. This shows the frames
elapsed or remaining depending on mode setting.
16. LOOP - shows when the CD is repeating a
particular area with the music on the CD.
17. RELOOP - shows when the CD has had a
loop set previously and can go back to it to
loop again.
TRANSPORT FEATURES
19. DISC TRAY- Place your CD in here.
20. OPEN/CLOSE (Disc Tray Open/Close) - Press to load or
eject the disc. Each press will open or close the disc tray
on the transport. NOTE: Tray will not open unless the
disc has been paused.
21. POWER BUTTON - Turn on and turn off the machine from
this button. The unit should always be shut down with this
button first before any external power is removed.
22. RCA AUDIO JACKS - Connect your CD player to your
mixer from this line level output.
23. VOLTAGE SELECTOR - Set this switch to the voltage for
your location.
24. POWER CONNECTOR - Plug your supplied power cord
into here then plug unit into a power outlet.
25. CONTROL CONNECTOR - Plug your control cables for
each unit into here and the back of the remote unit.
26. DIGITAL OUTPUTS - The format is type 2, form 1, also
known as S/PDIF (Sony/Phillips Digital Interface Format).
In order to use the digital output you must set the digital
output selector to on. This will deactivate the variable
pitch slider and the pitch bend buttons or pitch wheel. If
you were able to adjust the pitch, other devices will not
read the digital output properly.