Filter
Top Products
2
3. Use the four supplied mounting screws to attach the antenna to the mounting surface. The o-ring com-
presses and creates a seal between the surface and the antenna.
Ref. # Description
1 Antenna
2 Countersink screws
3 Mounting surface
4 O-ring
5 Pre-drilled mounting holes
4. Remove the dust cap from the antenna’s TNC connector.
5. Attach the coaxial cable’s male TNC connector to the antenna’s TNC connector.
Ref.# Description
1 Mounted antenna
2 Mounting surface
3 TNC connector
4 Coaxial cable
6. Attach the other end of the coaxial cable to the antenna input port on the receiving device. The
receiving device must be equipped to provide power as detailed in the SPECIFICATIONS section of
this guide. All NovAtel GPS receivers provide the necessary power through the antenna RF
connectors.
NovAtel recommends thread-locker (not included) on the mounting screws.
1
2
3 4
5