Niles Audio SW-800 Speaker User Manual


 
Infrared Sensor Mount
The speaker baffle has a locator
designed for the Niles MS-1
MicroSensor, a miniature
infrared sensor. The MS-1
installs discreetly behind the
aluminum grille and therefore
minimizes wall clutter in your
home. When you want to con-
trol your equipment, you simply
point your remote control at the
speaker with the MS-1 installed
from up to 15 feet away.
Low Diffraction,
Paintable Aluminum
Grilles
The MicroPerf
aluminum
grille has hundreds of precisely
sized perforations, creating an
acoustically transparent grille.
It is rustproof and can be
repainted to match your walls.
SA-100 Subwoofer
Amplifier
The SA-100 incorporates an elec-
tronic crossover which divides the
signal into deep bass (for the SA-
100/SW-800) and the midrange
and treble (for your main amplifier
and speakers). Your existing
amplifier and speakers will no
longer attempt to reproduce deep
bass tones. As a result, there will
be a huge (approximately 6dB)
increase in their dynamic capabil-
ity. Your system will sound much
better (in the highs and lows) at
higher volumes!
There are level, phase and bypass
controls enabling you to calibrate
the system to any room configura-
tion. With built in music sense cir-
cuitry, it turns itself on when you
start playing the music, and it
shuts itself off when youre
through listening.
Up to four SW-800s are powered
by a single SA-100 power ampli-
fier. The SA-100 delivers over 140
watts to two subwoofers connect-
ed in parallel. Additional sub-
woofers can be added by com-
bining series and parallel connec-
tions to maintain a nominal four
Ohm load impedance. The SA-
100 has thermal, DC offset and
overload protection.
SW-800 In-Wall Enclosure
In developing the Subwoofer
system, Niles targeted a prob-
lem inherent in conventional
in-wall subwoofers
_
they radi-
ate as much as 50% of their
bass output into the surround-
ing wall. But thats not all. This
wayward bass is out of phase
with the bass projected for-
ward. When the two wave-
forms combine, some cancella-
tion occurs, which translates to
weakened and unbalanced
bass. With the SW-800 enclo-
sure, Niles solves this problem.
SA-100 AMPLIFIER
SPECIFICATIONS
FREQUENCY
RESPONSE
20 Hz to 100Hz
POWER
100 watts RMS into 8
Ohms at less than .05%
THD. 140 watts RMS
into 4 Ohms at less than
0.1% THD
SIGNAL TO NOISE
Greater than 90dB
CROSSOVER
FREQUENCY
100Hz @ 24dB per
octave
OVERALL DIMENSIONS
17" Wide x 3-7/8" High x
12" Deep
SW-800 IN-WALL
ENCLOSURE
SPECIFICATIONS
DESIGN
Acoustic Suspension
CONSTRUCTION
Glued and internally
braced 1/2 medium
density fiber board,
vinyl wrapped
MOUNTING
Supplied screws are
driven through adjoining
studs into the enclosure.
OVERALL DIMENSIONS
14-1/4" wide x 42-1/4" high
x 3-1/4" deep
(mounts in a standard
stud wall )
SW-800 In-Wall Subwoofer System
©1996 Niles Audio Corporation, Inc. Blueprint Series In-Wall Loudspeakers, Niles and the Niles logo are registered trademarks of Niles Audio Corporation, Inc. Blending High Fidelity and Architecture,
X-Matrix, MicroPerf and MicroSensor are trademarks of Niles Audio Corporation, Inc. Note: Because Niles believes in constantly improving its products, Niles reserves the right to change product spec-
ifications without notice. Printed in USA LT00031A
FEATURES AND BENEFITS (CONTINUED)
FEATURES AND BENEFITS (CONTINUED)
APPLICATION NOTES
APPLICATION NOTES
TAPE CD AUX VID
FM
101.5
From the Pre-Outs of
the Receiver
To the Main-Ins
of the Receiver
Left Main
Speaker
Right Main
Speaker
SW-800 #1 SW-800 #2
SA-100
Receiver
From the Front Main
Speaker Outputs
of the Receiver
SW-800 Subwoofer System Connected to a
Receiver with a Pre-Out/Main-In loop.
CHARTER MEMBER
Consumer Electronics
Manufacturers Association
A sector of the EIA
®
NILES AUDIO CORPORATION, INC.
12331 S.W. 130 STREET MIAMI, FLORIDA 33186
TEL: (305) 238-4373 FAX: (305) 238-0185