Niles Audio SSVC-6 Stereo Amplifier User Manual


 
Installation
1. Select a convenient location for the SSVC-2/4/6 .
2. Run all the necessary wiring to the SSVC-2/4/6 . Label the
wires for future reference. See (Figure 1).
3. Locate the connector plugs (and remove them if they are
plugged in). See (Figure 2) and (Figure 4).
4. Strip 1/4" of insulation from the end of each wire. Tightly
twist the end of each wire until no frayed ends remain.
SSVC-2 connector installation
a. On the SSVC-2 use a small flathead screwdriver or your
thumbnail to raise the locking tabs, exposing the holes on
the removable connector plug.
b. Insert each wire into the appropriate hole on the removable
connector plug, and snap the locking tab down.
NOTE: To help you avoid improper installation, the
connector plug is keyed.
c. Insert the smooth side of the connector plug into the
smooth side of the socket. Don’t force the scalloped side of
the connector plug into the smooth side of the socket. See
(Figure 2).
8
S
PEAKER
S
ELECTION
/V
OLUME
C
ONTROL
S
YSTEM
Type of Speaker Wire
For most applications, we recommend you use 16 or 18
gauge stranded copper speaker wire for the SSVC-2/4/6 con-
nections. For wiring runs longer than 80 feet, 14 gauge wire is
recommended. Using speaker wire larger than 14 gauge for
SSVC connections is not recommended—the wire may not fit
into the connectors. Never use solid-core, aluminum, or
“Romex” type wire with the speaker selector. When running
speaker wires inside walls, most states and municipalities in
the U.S. specify that you must use a special type of speaker
wire. Usually, the requirement is that the wire has a specific
“CL” fire rating, such as “CL-2” or “CL-3”. Consult your Niles
dealer, building contractor, or local building and inspection
department if unsure about which type of wire is best for
your application.
Avoiding Interference
Speaker wires can act as an antenna for electrical noise.
Locating speaker wires too close to a light dimmer or switch
may cause a “buzzing” or “popping” sound to be heard
thought the speakers. If you must locate the SSVC series
wiring near electrical devices, route the speaker wires several
feet away from the electrical wiring.
7
S
PEAKER
S
ELECTION
/V
OLUME
C
ONTROL
S
YSTEM
DS00357ACN/SSVC-2/4/6 Printer 11/19/03 5:11 PM Page 7