Filter
Top Products
SPECIFICATIONS LINEAR LIMITED WARRANTY
This Linear product is warranted against defects in material and workmanship for twelve
(12) months. This warranty extends only to wholesale customers who buy direct from Linear
or through Linear’s normal distribution channels. Linear does not warrant this product to
consumers. Consumers should inquire from their selling dealer as to the nature of the
dealer’s warranty, if any. There are no obligations or liabilities on the part of Linear LLC
for consequential damages arising out of or in connection with use or performance
of this product or other indirect damages with respect to loss of property, revenue, or
profi t, or cost of removal, installation, or reinstallation. All implied warranties, including
implied warranties for merchantability and implied warranties for fi tness, are valid only until
the warranty expires. This Linear LLC Warranty is in lieu of all other warranties express
or implied.
All products returned for warranty service require a Return Product Authorization Number
(RPA#). Contact Linear Technical Services at 1-800-421-1587 for an RPA# and other
important details.
IMPORTANT WIRELESS INFORMATION
Linear radio controls provide a reliable communications link and fi ll an important need in
portable wireless signaling. However, there are some limitations which must be observed.
• For U.S. installations only: The radios are required to comply with FCC Rules and
Regulations as Part 15 devices. As such, they have limited transmitter power and
therefore limited range.
• A receiver cannot respond to more than one transmitted signal at a time and may be
blocked by radio signals that occur on or near their operating frequencies, regardless of
code settings.
• Changes or modifi cations to the device may void FCC compliance.
• Infrequently used radio links should be tested regularly to protect against undetected
interference or fault.
• A general knowledge of radio and its vagaries should be gained prior to acting as a
wholesale distributor or dealer, and these facts should be communicated to the ultimate
users.
21. NON-VOICE PROMPT BEEP LEGEND
22. REMOTE AUDIO COMMUNICATIONS
23. WIRELESS INSTALLATION TIPS
Copyright © 2008 Linear LLC 228305 A
CODING FORMATS
DX CODE 24-BIT A1D PPM 1,048,567 CODES
DXS CODE 24-BIT A1D PPM 1,048,567 CODES
POWER REQUIREMENTS
PRIMARY SUPPLY 16 VAC 1.25 AMP PLUG-IN TRANSFORMER
BACKUP SUPPLY 12 VOLT 1.2 AMP/HOUR BATTERY
NORMAL OPERATING CURRENT 120 mA
ALARM OPERATING CURRENT 190 mA
BACKUP OPERATION DURATION 30 HOURS MINIMUM
BATTERY LIFE EXPECTED 3 YEARS
BACKUP SUPPLY OPERATING CURRENT 40 mA
BATTERY FUSE 1 AMP, TYPE 2AG
RF CHARACTERISTICS
RECEIVER TYPE DUAL-DIVERSITY SUPERHETERODYNE
RF SENSITIVITY -100 dBm TYPICAL
RADIO FREQUENCY 315 Mhz
MAXIMUM RANGE 400 FEET LINE-OF-SIGHT, OPEN RANGE
UL LISTED FOR 150 FEET
COMMUNICATOR
COMMUNICATOR FORMATS 4 BY 2 (GENERAL OR POINT-TO-POINT),
ADEMCO CONTACT ID
UL TESTED WITH SURGARD SGMLRG-DG
CENTRAL STATION RECEIVERCENTRAL STATION RECEIVER
DIALING TONE OR PULSE
DIALING DELAY 0 OR 15 SECONDS
REMOTE PROGRAMMING PASSWORD 6 DIGITS
REMOTE COMMUNICATIONS PASSWORD 4 DIGITS
ACCOUNT NUMBER LENGTH 4 DIGITS
PRIMARY TELEPHONE NUMBER 20 DIGITS
SECONDARY TELEPHONE NUMBER 20 DIGITS
SUPERVISORY TELEPHONE NUMBER 20 DIGITS
CONSOLE STATUS REPORT OPTIONAL 1, 7 OR 30 DAY REPORT
CONSOLE
OPERATING TEMPERATURE 32°-120° F (0-49° C)
HELP ALARM DURATION 1-30 MINUTES
ACTIVITY TIMER PERIOD 8, 12, OR 24 HOURS
AUDIO LISTEN-ONLY, 2-WAY MANUAL, 2-WAY VOICE
ACTIVATED (DUPLEX) SPEAKERPHONE
RELAY OUTPUT N.O. @ 24 VOLT AC/DC 1 AMP
MAXIMUM, NEC CLASS II CIRCUITRY
LIGHT CONCRETE
OR BRICK
65% - 95%
OF FULL POWER
10% - 70%
OF FULL POWER
CONCRETE WITH STEEL
REINFORCEMENT OR
METAL LATH AND PLASTE
R
WALLBOARD AND
WOOD STUDS
90% - 100%
OF FULL POWER
CONSTRUCTION
MATERIALS WILL
AFFECT RADIO RANGE
WRONG!
RIGHT
CENTRALLY LOCATE CONSOLE
TRANSMITTERS AT THE
OTHER END OF THE HOUSE
MIGHT BE TOO FAR AWAY
CONSOLE LOCATION WILL
AFFECT RADIO RANGE
WHEN VOICE PROMPTS ARE DISABLED, THE CONSOLE WILL SOUND BEEPS
TO INDICATE VARIOUS CONDITIONS
1 BEEP ...................TRANSMITTER ADDED TO A SENSOR ZONE
1 LONG BEEP ........SENSOR ZONES FULL
2 BEEPS .................CONSOLE IN STANDBY MODE, ACTIVITY TIMER ON
3 BEEPS .................CONSOLE IN STANDBY MODE, ACTIVITY TIMER OFF
4 BEEPS .................CONSOLE IN TEST MODE
5 BEEPS .................CONSOLE IN LEARN TRANSMITTER MODE
6 BEEPS .................CONSOLE HAS ERASED ALL TRANSMITTERS
7 BEEPS .................PULSE DIALING HAS BEEN SELECTED FOR THE CONSOLE
8 BEEPS .................TONE DIALING HAS BEEN SELECTED FOR THE CONSOLE
TO ESTABLISH REMOTE AUDIO COMMUNICATIONS WITH THE CONSOLE:
1. DIAL THE NUMBER OF THE PHONE LINE THAT THE CONSOLE IS CONNECTED TO,
ALLOW IT TO RING THREE TIMES, THEN HANG UP
2. WAIT ABOUT 10 SECONDS, THEN CALL THE CONSOLE A SECOND TIME
3. WHEN THE CONSOLE ANSWERS, A TONE WILL SOUND FOR ABOUT 8 SECONDS
4. WHEN THE TONE ENDS, ENTER THE REMOTE AUDIO PASSWORD (DEFAULT 1234)
FOLLOWED BY THE # KEY
THE CONSOLE WILL BEGIN AUDIO COMMUNICATIONS (2-WAY DUPLEX, 2-WAY MANUAL,
OR LISTEN-ONLY) DEPENDING ON THE CONSOLE’S PROGRAMMING
SEE SECTION 16 FOR AUDIO COMMUNICATION OPERATION DETAILS
NOTE: IF THE CONSOLE AUDIO IS SET TO “NONE” REMOTE AUDIO COMMUNICATIONS
WILL NOT FUNCTION
NOTE: THE INSTALLER MUST
VERIFY COMPATIBILITY
BETWEEN THE PERS-3600B AND
THE UL LISTED DIGITAL ALARM
COMMUNICATOR RECEIVER