Filter
Top Products
INSTALLING A NILES MS-100 MICROSENSOR
®
1. For each speaker, locate the half-inch round, molded “IR Sensor Knockout”
on the baffle.
2.
Lay each speaker face down on a clean carpet or rug. Put the tip of a screwdriver
into the center of the round “knockout” and sharply tap the screwdriver handle
as necessary.
NOTE: TO PREVENT DAMAGE TO THE CROSSOVER NETWORK, ALWAYS REMOVE A KNOCKOUT
FROM THE REAR OF THE SPEAKER. DO NOT ATTEMPT TO REMOVE A KNOCKOUT WITH THE
SPEAKER FACE UP.
3. At each speaker, install the MS-100 (using its mounting hex nut and washer) until it is
tightly secured.
4.
Connect all MS-100 wires.
SETTING THE CTR L/R MODE
The HDLCR includes a baffle-mounted CTR L/R mode switch to optimize performance in
applications as either a center channel or left/right loudspeaker for front-channel use, as shown
in Figure 14.
• For front left- or right-channel applications, slide the HDLCR’s mode switch to L/R.
• For center-channel use, slide the HDLCR’s mode switch to CTR.
18
Figure 14. The HDLCR’s CTR L/R mode switch.
CTR
L/R