Nady Systems PCS-12 Speaker System User Manual


 
(U.S.) Should your NADY AUDIO product require service, please contact the Nady Service Department via telephone at (510) 652-
2411 or e-mail at service@nady.com.
(International) For service, please contact the NADY AUDIO distributor in your country through the dealer from whom you purchased
this product.
SERVICE
FOR YOUR NADY AUDIO PRODUCT
NADY SYSTEMS, INC. 6701 SHELLMOUND STREET, EMERYVILLE, CA 94608
Tel: 510.652.2411 • Fax: 510.652.5075 • www.nady.com
SPECIFICATIONS
TECHNICAL DATA
(1) POWER ON/OFF SWITCH
(2) AC POWER CORD IEC CONNECTOR w/ internal fuse holder
Connects to the AC power cable. Fuse: 115VAC ~ 5A 250V 20mm glass tube
230VAC ~ 3A 250V 20mm glass tube
(3) AC SELECTOR SWITCH
Before plugging in the power cord, check to see that this switch is set to the proper voltage for
your area: ~115V (60Hz) or ~230V (50Hz).
Note: Units damaged due to powering up with the wrong voltage are not covered under warranty.
(4) POWER ON LED
(5) CLIPPING LED
This LED turns red when the output signal is clipping. It is acceptable if the red LED lights
occasionally. If the red LED lights more than occasionally, you should turn down the volume to
avoid audible distortion and damage to the speaker.
Note: Speakers damaged due to hard clipping are not covered under warranty.
(6) MIC INPUTS
Balanced XLR and 1/4" TRS inputs for use with a mic level input signal.
(7) MIC LEVEL CONTROL
(8) LINE 1 INPUTS
Balanced XLR and 1/4" TRS inputs for use with a line level input signal.
(9) LINE 1 LEVEL CONTROL
(10) LINE 2 INPUTS
Balanced XLR and dual RCA inputs for use with line level input signals.
(11) LINE 2 LEVEL CONTROL
(12) LINE OUTPUTS
Balanced XLR and 1/4" TRS outputs. Master Volume/Bass/Treble controls do not effect these
outputs.
(13) MASTER VOLUME CONTROL
This controls the volume sent to the speaker. Make sure to turn this
(14) TREBLE EQ
Adjusts treble frequencies +/-12dB.
(15) BASS EQ
Adjusts bass frequencies +/-12dB.
(6)
(2)
(3)
(4)
(5)
(7)
(8)
(9)
(10)
(11)
(12)
(14)
(13)
(1)
(15)
SPECIFICATIONS
Frequency Range: <20 Hz - 20 kHz (0dB/-10 dB)
Frequency Response: 20 Hz - 12 kHz (±3 dB)
Treble EQ: ±12 dB @ 6 kHz
Bass EQ: ±12 dB @ 55 Hz
LF Driver: 15" (380 mm) driver
HF Driver: Titanium compression driver 1” voice coil
Amplifier Power: 400W Peak (200 W RMS) @8 ohms
Speaker Power Handling: 600W Peak (300 W RMS)
Max SPL: 102dB @1M
Sensitivity (1W/1M): 96dB
Total THD: <5%
Weight: 50.1 lbs (22.7 Kg)
Dimensions (WDH): 17.3” x 26.6” x 13.6” (43.9 cm x 67.6 cm x 34.5 cm)