Filter
Top Products
4
INSTALLATION
To ensure years of enjoyment from your NADY AUDIO graphic
equalizer, please read and understand this manual thoroughly
before using the unit.
These three equalizer models are each designed for mounting in
a standard 19” equipment rack or one of the many rack type por-
table cases available on the market. The units are either 1u single
rack (1.75”) or 2u double rack (3.5”) as noted. All three models
are 5 inches deep.
Install the equalizer in a rack with rack screws (not included).
Route the A.C. power cord to a convenient power outlet away
from audio lines. The unit may be turned on and off from the front
panel power switch or a master equipment power switch. Since
the unit draws a relatively small amount of current during idle, the
unit may be left on continuously. NADY AUDIO equalizers do not
generate an unduly large amount of heat and do not need to be
specially ventilated or cooled. The units should not be subjected,
however, to high heat environments.
Although the unit is shielded against radio frequency (RF) and
electromagnetic interference (EMI), extremely high fields of RF
and EMI should be avoided.
Paralleling inputs and outputs may be accomplished by using any
of the 2 connectors.
POWER CONNECTION
Each of these three NADY AUDIO graphic equalizers is designed
for operation with 105-130 volts AC at 60Hz power sources .
Power requirements for electrical equipment differ from area to
area. In new installations and portable sound systems, or any
situation in which the AC power is in question, it is wise to confirm
the voltage before connecting the instrument to power sources.
PRECAUTIONS
Protecting yourself from electric shock:
Never touch the plug with wet hands.
Always pull out by the plug and never the cord.
Only let a qualied professional repair the equipment. An
unauthorized person might touch the internal parts and
receive a serious electric shock. Note: Removing the chassis
screws and opening the unit will automatically void your
warranty.
Never allow a child to put anything into the equipment.
Protecting your NADY AUDIO Graphic Equalizer:
Use only a household AC power source. Never use a DC
•
•
•
•
•
power source.
If water is spilled on or in the unit, unplug it and call for
service.
Make sure that the equipment is well ventilated and away
from direct sunlight
Avoid damage to the internal circuits and the external
surface by keeping the unit away from sources of high heat.
Avoid using spray type insecticide or solvents near the
equipment. It can damage the nish an might ignite suddenly
To avoid damaging the nish, never use denatured alcohol,
paint thinner or other similar chemicals to clean the
equipment.
Place the unit on a at and solid surface or in a rack.
To enjoy your NADY AUDIO graphic equalizer for a long
time, please read this owner’s manual thoroughly.
•
•
•
•
•
•
•
Installation