Nady Systems CX-22SW Speaker User Manual


  Open as PDF
of 7
 
PLEASE READ THIS MANUAL BEFORE OPERATING THIS UNIT
Caution : To prevent malfunctioning and/or possible equipment damage:
Before plugging the unit into the power source: (1) the voltage selector switch should be set
for the correct voltage for your area (115V or 230V) and (2) all equipment connected to the
crossover outputs should be turned off or all the inputs turned down.
1. ON/OFF SWITCH
Caution: Always turn the Crossover ON before the amplifier, and turn it OFF after the amplifier or
transients harmful to the speakers may result .
2. CROSSOVER FREQUENCY CONTROLS:
These select the crossover frequencies of the LOW and HIGH ways.
They’re a low cut for the HIGH and a high cut for the LOW. You can
Select the frequencies between 250 Hz and 6 Hz.
3. L/H OUTPUT LEVEL CONTROLS:
These are used to adjust the output level of each way: LOW and HIGH .
4. LOW CUT SWITCHES FOR LOW WAY:
These insert low cut filters in the LOW way of each stereo channel with a 12dB/Octave, 30 Hz HPF
to minimize problems from subsonic frequencies in the signal, to suppress hum, and to prevent low
frequency speaker resonance.
CONTROLS AND CONNECTIONS
CONTROLS
115V/60Hz
230V/50Hz
AC IN FUSE 0.5A
HIGH LOWOUTPUT INPUT WOOFER
R CHANNEL
OUTPUT
L CHANNEL
HIGH LOW INPUT
XLR
BALANCED
PIN
1
GND
PIN
2
HI
PIN
3
LO
RCA UNBAL
SUB
Emeryville, CA, USA
Made in Taiwan
NADY SYSTEMS, Inc.
3 3
6
3 4
2 3 5 15 7 824
13 12 9 11 1110 1011
4
 previous next