Filter
Top Products
PRE-AMP SECTION
Phono input
Input impedance (R and C) MM 47kΩ / 120pF
MC 47kΩ / 120pF
Input sensitivity, 1kHz MM 0.28mV ref. 1W
MC 0.02mV ref. 1W
Signal/Noise ratio (A-weighted with cartridge connected) MM 76dB ref. 5mV
MC 76dB ref. 5mV
THD (20Hz - 20kHz) <0.04%
RIAA response accuracy (20Hz - 20kHz) ±0.5dB
Line level inputs
Input impedance (R and C) 50kΩ / 250pF
Input sensitivity (ref. 1W) 15mV
Maximum input signal >10V
Signal/Noise ratio (A-weighted ref 1W) 96dB
Frequency response (20Hz - 20kHz) ±0.3dB
Line level outputs
Output impedance Pre-amp 600Ω
Tape Source Z + 1kΩ
Maximum output level >10V
Tone controls
Treble ±12dB at 3, 6 or 12kHz
Bass ±12dB at 50, 120 or 250Hz
Bass EQ +3dB at 60Hz
+6dB at 36Hz
Infrasonic filter (Switchable) -3dB at 12Hz, 12dB / octave
POWER AMP SECTION
Continuous output power into 8Ω * 100W (20dBW)
Rated distortion (THD 20Hz - 20kHz) 0.03%
Clipping power (maximum continuous power per channel) 130W
IHF Dynamic headroom at 8Ω +5.7dB
IHF dynamic power (maximum short term power per channel) 8Ω 370W (25.7dBW)
4Ω 400W (26dBW)
2Ω 440W (26.4dBW)
Damping factor (ref. 8Ω, 50Hz) >100
Input impedance 20kΩ / 600pF
Input sensitivity (for rated power into 8Ω) 1V
Frequency response 3Hz - 100kHz +0, -3dB
Signal/noise ratio ref. 1W 98dB
ref. rated power 118dB
THD (20Hz - 20kHz) <0.03%
Bridged Mode
Continuous output power into 8Ω * 200W (23dBW)
IHF Dynamic headroom at 8Ω +6dB
IHF dynamic power (maximum short term power per channel) 8Ω 800W (29dBW)
4Ω 880W (29.4dBW)
© NAD Electronics. All rights reserved. E & OE