NAD 7020e Stereo Receiver User Manual


 
PRE-AMP SECTION
Phono input
Input impedance (R and C) 47k/ 100pF
Input sensitivity, 1kHz 2.4mV ref. 20W
Signal/Noise ratio (A-weighted with cartridge connected) 75dB ref. 5mV
THD (20Hz - 20kHz) <0.04%
RIAA response accuracy (20Hz - 20kHz) ±0.5dB
Line level inputs
Input impedance (R and C) 40k/ 100pF
Input sensitivity (ref. 20W) 150mV
Maximum input signal >10V
Signal/Noise ratio (A-weighted ref 1W) 84dB
Frequency response (20Hz - 20kHz) +0.5dB, -1.0dB
Infrasonic filter -3db at 15Hz, 24dB/octave
Line level outputs
Output impedance Tape Source Z + 1k
Phones 220
Maximum output level Tape 10V
Phones >10V into 600
>500mV into 8
Tone controls
Treble ±7dB at 10kHz
Bass ±10dB at 50Hz
POWER AMP SECTION
Continuous output power into 8* 20W (13dBW)
Rated distortion (THD 20Hz - 20kHz) 0.03%
Clipping power (maximum continuous power per channel) 25W
IHF Dynamic headroom at 8 +2.5dB
IHF dynamic power (maximum short term power per channel) 8 35W (15.5dBW)
4 35W (15.5dBW)
2 50W (17dBW)
Damping factor (ref. 8, 50Hz) >30
Input sensitivity (for rated power into 8) 900mV
FM TUNER SECTION
Input sensitivity Mono -30dB THD+N 11.3dBf (2.0µV/300)
Mono 30dB S/N 15dBf (3.0µV/300)
Stereo 50dB S/N 37dBf (40µV/300)
Stereo 60dB S/N 47dBf (120µV/300)
Capture ratio (45 - 65dBf) <1.5dB
AM rejection (45 - 65dBf) >60dB
Selectivity, alternate channel 58dB
Image rejection 70dB
I F rejection 90dB
Harmonic distortion Mono 0.1%
Stereo 0.1%
Signal/Noise ratio Mono >80dB
Stereo >74dB
Frequency response ±0.5dB 30Hz - 15kHz
Channel separation at 1kHz 45dB
AM TUNER SECTION
Usable sensitivity 5µV
Selectivity 30dB
Image rejection 45dB
I F rejection 35dB
Signal/Noise ratio 45dB
Harmonic distortion 0.5%
Remote No
NAD Link No
PHYSICAL SPECIFICATIONS
Dimensions (W x H x D) 420 x 91x 273mm
Net weight 5.5kg
Shipping weight 6.8kg
Power consumption (120 ~ 240V, 50/60Hz) 150W
* Minimum power per chnnel, 20Hz - 20kHz, both channels driven with no more than rated distiortion.
Dimensions are of unit’s cabinet without attached feet; add up to 18mm for total height.
Dimension depth excludes terminals, sockets, controls and buttons.
© NAD Electronics. All rights reserved. E & OE