Filter
Top Products
X-PLORA
V8
POWER SUPPLY OPTIONS & WIRING
Issue 3: 19
th
October 2006
3-component setup, standard power supply
X-PLORA
V8
TRIPLE-X
X-RAY
V8
XT-100
Figure 1
The standard 3-component setup using the original
TRIPLE-X PSU (bottom left) is shown in figure 1.
The power connector from the X-PLORA
V8
mates with
the 4-way socket labelled X-PLORA
V8
on the rear of the
TRIPLE-X PSU. The connector should fit comfortably
with a small click when properly seated.
The power connector from the X-RAY
V8
mates with the
5-way socket labelled X-RAY
V8
on the rear of the
TRIPLE-X PSU. The connector should fit comfortably
with a small click when properly seated.
The power connector from the XT-100 Integrated
amplifier mates with the 6-way socket labelled XT-100
on the rear of the TRIPLE-X PSU. The connector should
fit comfortably with a small click when properly seated.
3-component setup, upgraded power supply
X-PLORA
V8
TRIPLE-X170 X-RAY
V8
XT-100
Figure 2
The upgraded 3-component setup using the TRIPLE-
X170 PSU (bottom left) is shown in figure 2.
The wiring is identical to that given under the standard
setup shown above. Simply remove the TRIPLE-X PSU
and use the TRIPLE-X170 PSU in its place.
4-component setup, upgraded power supply
X-PLORA
V8
X-RAY
V8
X-DAC
V8
XT-100
TRIPLE-X170
Figure 3
The recommended power supply wiring for the four-
component setup, including upgrade power supply and
X-DAC
V8
, is shown in figure 3.
The power connector from the X-PLORA
V8
mates with
the 4-way socket labelled X-PLORA
V8
on the rear of
the X-DAC
V8
. The connector should fit comfortably
with a small click when properly seated.
The power connector from the X-RAY
V8
mates with
the 5-way socket labelled X-RAY
V8
on the rear of the
X-DAC
V8
.The connector should fit comfortably with a
small click when properly seated.
The XT-100 integrated amplifier should be powered
from the upgrade TRIPLE-X170 power supply unit.
Connect your XT-100 to this supply through the 6-way
XLR socket at the back. The X-PLORA
V8
and X-
RAY
V8
are now supplied from the X-DAC
V8
. This frees
up reserve supply for the power amplifiers in the
XT100.
This is by no means an exhaustive list, as it is possible
to use the original TRIPLE-X power supply, say, to
supply the CD player alone further isolating it from the
DAC and other circuits. The beauty of this system is its
incredibly flexible allowing considerable tweaking to
obtain optimum audio performance.
Page 6
of
14