Filter
Top Products
OPERATION
Issue 2 Page 10 of 13
TAPE
To use the TAPE input, connect external source to the TAPE input (see page 7). Select TAPE input by pressing
the TAPE button so TAPE LED is lit. Selecting the TAPE input can also be achieved by pressing the
corresponding button on the remote handset (see page 8).
TAPE REC
To record to tape, (or alternatively CD recorder, DAT, minidisk or computer soundcard analogue input) connect
the tape out to the recorder unit line in. Press the input selector button on the front panel or remote control. This
source will now be routed to the M6 500i TAPE REC for recording by the recording unit.
TAPE MONITOR
The recording can be directly monitored through the loudspeakers by pressing the TAPE MONITOR button so
the TAPE MONITOR LED is lit. Press again to return back to the original input being listened to (and TAPE
MONITOR LED is out again).
On some 3 head tape decks there is an additional tape/source switch which should be in the 'TAPE' position for
this to work. If in doubt, please consult tape deck operating manual.
Note – adjustment of the volume control has no effect on the TAPE REC level.