Filter
Top Products
Issue 3: March 2005
A5 CD Instructions for use Page 13 of
16
SPECIAL FEATURES
SCAN INTRODUCTION
The scan-introduction function allows play
back of just the start of each track on the disc,
for instance to locate a preferred track by ear.
Press INTRO on the remote control, and if
the player has stopped, the display will show :
The first ten seconds (approximately) of each
track on the CD can then be played in
sequence by pressing either PLAY/PAUSE
on the front panel, or PLAY on the remote
control.
Press INTRO again to cancel introduction
search mode. If INTRO mode is cancelled
while the A5 CD is still playing, the
remainder of the entire disc will be played.
PROGRAMMED PLAY
The built-in program memory allows you to
store up to 25 track numbers and then play
them back in the held order. Each track is
stored as a “step” in the program.
With the CD loaded and the player stopped,
first press PROGRAM on the remote control.
The following is then displayed :
On the remote control, press the numeric
button of the track number corresponding to
the first track you wish to store (number 3 for
example).
(continued . . .)
That track number will now appear in the
display :
Press PROGRAM again on the remote
control - the next program step is selected,
(prog 2) and the track number reverts to zero
ready for a new entry :
Continue entering track numbers in the same
way up to a maximum of 25. If more than 25
tracks are attempted accidentally, the memory
will not accept any extra ones, and the display
reverts to “prog 1”.
Remember that when entering a single-digit
track number, there is a delay of about two
seconds before the display accepts the entry -
this is to allow time for a second button to be
pressed when a double-digit number is
required.
If an incorrect entry is made, say track 9 when
there are only 7 tracks available on the disc,
“INVALID TRACK” is briefly shown, and
the entry automatically cancelled.
If at any time you wish to add a track to the
list, press the CLEAR button to obtain the
next step number. Alternatively, to delete a
previous entry, press CLEAR a second time
to remove the last entry. Repeated pressing of
CLEAR will then erase each step in reverse
order. So to delete an entire program
sequence from the memory, press CLEAR
repeatedly until “prog 1” is shown in the
display.
When the last track number has been entered,
press PROGRAM a final time, then the
PLAY button to start the program sequence.
(continued . . .)