Filter
Top Products
STEP 1
Using a stud finder (available at low cost at most hardware stores) or
other accurate method, locate center point between two joists and
mark. Using template provided, trace hole pattern on surface of ceiling.
STEP 2
Using a sabre saw, keyhole saw or very sharp utility knife, cut hole in ceil-
ing, following traced pattern.
STEP 3
Run loudspeaker wires to sound source location. There are several meth-
ods you can use to accomplish wiring, depending on the construction
characteristics of the room or house. You can add a professional touch
to your installation by using a speaker terminal plate at the source loca-
tion. Leave sufficient amount of wire at speaker location (8 to 10 inches)
to complete connection.
STEP 4
Attach loudspeaker wires to speaker terminals, observing correct polarity,
and position speaker frame up into cutout. Be careful not to pinch wires in
the process.
STEP 5
Carefully tighten the four mounting screws, using a phillips screwdriver. This
will cause the mounting wings to rotate out behind the mounting surface
and secure the speaker in place.
Note: the phillips head screws are for tight-
ening the mounting wings. The torx head screws are for the enclosure which
should not be tightened or loosened.
STEP 6
After speaker panel is secured tightly, test for sound. When you are satisfied
the speaker is operational, affix grill. As the grill is designed for a snug fit, you’ll
need to position one edge into the slot first, press or squeeze around perime-
ter of the grill, while pushing leading edge into the grill slot.