Filter
Top Products
Page 5
bracket (refer to Figure 1).
CONNECTING YOUR SPEAKERS
The WS5 speakers come with 5-way, gold plated,
binding posts. The binding posts are color-coded for
polarity—red is positive (+) and black is negative (-).
Follow the steps below for connecting your WS5
speakers:
1. Turn off the receiver or amplifier and unplug it from
the power outlet.
2. Use a 2-conductor 16-gauge speaker wire (M&S part
number MS16X5) for runs up to 100 feet. For
additional information on speaker wire runs contact
our Technical Support team at 1-800-366-9422.
NOTE: REMOVE ABOUT 2 INCHES OF THE OUTSIDE JACKET
FROM BOTH ENDS OF THE WIRE THEN STRIP APPROXIMATELY
½
INCH OF THE INSULATION FROM EACH CONDUCTOR AT
THE SPEAKER END. USE THE RECOMMENDED STRIP LENGTH AS
SPECIFIED IN THE AMPLIFIER/RECEIVER INSTALLATION MANUAL
Figure 1—Mounting bracket installation