7
Eject button
STEP 1 - open magazine door and
press the eject button.
STEP 2 - Wait for the magazine to
extend and stop (approximately 1
inch outward).
STEP 3 - Pull the magazine
from the MCD6 player and close
the sliding door.
UNLOADING DISC MAGAZINE
Unloading the disc magazine is performed by first sliding the access door to the right.
Next, press the eject button located below the window on the magazine. Pressing this
button will activate the magazine release mechanism. When ejected, the magazine will
extend outward 1". You may then pull the disc magazine out completely.
8
CARE AND MAINTENANCE
No maintenance is required to provide reliable operation. The MCD6 can be cleaned using
a slightly dampened cloth. No chemicals should be used to clean the face panel
components. Many common household chemicals may damage or discolor the face panel
components. Use care when cleaning the display window.
TROUBLESHOOTING TIPS
Will not power on Check for tripped circuit breaker.
Magazine will not eject Sliding door not opened fully.
"Err 07" displays when
disc is selected for play
Disc is not readable or is installed in the magazine
upside down. Disc must be installed with the label up.
"Err 07" displays while
disc is playing
Disc is dirty, damaged, or scratched.
Display does not light Press Track up and Mode at the same time and hold
for 3 seconds to enable.
"Err 01" displays Disc is jammed. Try ejecting the magazine.
Shipping screws have not been removed upon
installation.
Display shows disc is
playing but nothing is
heard
AUX is not selected on the radio-intercom master.
Check to see if FM or AM plays on the radio
intercom. If not, refer to troubleshooting section in the
owner's guide for the radio-intercom master.
Manual Reset Procedure
In some cases, performing a reset on the MCD6 may resolve your problem. First try
resetting the MCD6 player by pressing the TRACK UP and POWER buttons at the same
time. If that does not work, remove the plastic front cover by pulling straight out and press
the RESET button below the keypad. If your MCD6 player still does not operate, please
contact your dealer or M&S Systems, Technical Support at (800) 366-9422.