Filter
Top Products
Fiber Driver
®
EM316EDFA User Guide
P/N 1294008-001 Rev D2 24
The boxes below illustrate two common parameters used with the show command.
Default settings are listed in the show defaults command output. These parameters
reflect the module boot configuration which is determined by DIP switches and firmware
programming. All lines in this display begin with “!” to indicate that they are comments for
information only.
The show config command displays the active environment settings currently in the
operational context. The lines beginning with “!” are comments added for clarity in the CLI
display only. The comment lines ending with “:” are headings that describe the settings listed
in this display.
The default parameter values are constant for each module, but can change to reflect DIP
switch settings. Changes to these parameter values are reflected in the show config
command output. Restoring the default values returns the module to its original operating
state. Preserve changes made to the configuration for use in future CLI sessions and beyond
a reboot by writing them to the startup-config file as described later in this section.
fiberdriver(slot/1.3)#
s
how defaults
slot 1.3
! description EM316EDFAv at 1.3
fiberdriver(slot/1.3)# slot 1.4
fiberdriver(slot/1.4)# show defaults
slot 1.4
! description EM316EDFA at 1.4
fiberdriver(slot/1.4)#
fiberdriver(slot/1.3)#
s
how config
slot 1.3
! Configured parameters that override defaults:
! Configured parameters that match defaults:
! Parameters that will follow defaults:
! description EM316EDFAv at 1.3
fiberdriver(slot/1.3)# slot 1.4
fiberdriver(slot/1.4)# show config
slot 1.4
! Configured parameters that override defaults:
! Configured parameters that match defaults:
! Parameters that will follow defaults:
! description EM316EDFA at 1.4
fiberdriver(slot/1.4)#