Filter
Top Products
11
TROUBLESHOOTING
PROBLEM – The PowerCenter is not receiving power.
Possible Cause #1
The PowerCenter is not turned On.
Possible Solutions
• Turn the PowerCenter switch On.
• Make sure the PowerCenter’s AC power plug is plugged into a properly grounded
120V wall outlet.
• In some cases, a wall switch may need to be thrown to make the wall plug come alive.
Try turning on the light switches located near the wall unit powering the PowerCenter.
Possible Cause #2
Too many devices drawing too much power are connected, causing an overload, throwing the Thermal Circuit Breaker.
Possible Solutions
• Press the PowerCenter Thermal Circuit Breaker button in to reset. Please allow 10 minutes
before attempting to reset. If you reset too soon, the breaker may prematurely sense
power overload and not allow unit to operate.
LIT_PRO2500_manual_G.qxd 11/10/2003 3:39 PM Page 18