Filter
Top Products
your system with multiple filters. If your receiver or controller is THX-certified or Dolby Digital AC-3 capable, you do not need
the BMC-MINI. All Dolby Digital AC-3 and THX certified controllers and receivers have the proper high and low-pass filters built
in. See Figure 2 below.
This filter will give you greater dynamic range, lower distortion, and an increased maximum output level. If you have any
questions about using them, please contact your dealer or M&K.
For wiring, see the BMC-Mini owner's manual.
USING SPEAKER WIRE CONNECTIONS
Some M&K subwoofer owners hook up their subwoofer by connecting it to their receiver or amplifier using speaker wires.
To do so, you make the same kind of connections that you would use for your satellite (or main) speakers, except that both the
left and right channels go to the subwoofer. (If you are using two subwoofers, connect one channel only to each subwoofer).
1. Run speaker wire between the Amplifier's Left channel output terminals and the Subwoofer's Left channel
"FROM AMPLIFIER" terminals.
a. Connect the Amplifier's Left channel Positive (+) terminal and the Subwoofer's Left RED (+) "FROM
AMPLIFIER" terminal.
b. Connect the Amplifier's Left channel Negative (—) terminal and the Subwoofer's Left BLACK (—)
"FROM AMPLIFIER" terminal.
2. Make matching connections for the Right channel. See Figure 3.
POWERED SUBWOOFER
6
100
9351 Deering Avenue, Chatsworth, CA 91311 818/701-7010 www.mksound.com
MILLER & KREISEL SOUND CORPORATION
RIGHT
INPUT
LOW PASS FILTER
(Hz)
FROM AMPLIFIER
50
75
60
125
T
2 AMP
120 VAC 50/60 Hz
RIGHT LEFT
LEFT/MONO
SLOW-BLOW
ATTENTION:
DEBRANCHER AVANT DE
REMPLACER LE FUSIBLE.
UTILIZER UN FUSIBLE
DE RECHANGE DE MEME TYPE.
CAUTION:
DISCONNECT SUPPLY CORD
BEFORE CHANGING FUSE.
REPLACE FUSE ONLY
WITH SAME TYPE.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
AVIS:
RISQUE DE CHOC ELECTRIQUE. NE PAS OUVRIR.
BASS LEVEL
+3 dB
+6 dB
- 3 dB
- 6 dB
REFERENCE
+9 dB
BYPASS
VARIABLE
!
+
+
+
+
AMPLIFIER OR RECEIVER
Stereo preamp or processor
BMC-Mini Bass
Management Controller
Power amplifier
M&K powered subwoofer
FIGURE 2 - CONNECTING TO A STEREO AMP OR PREAMP WITH THE BMC-MINI (OPTIONAL)
FIGURE 3 - TO AN AMP OR RECEIVER USING SPEAKER WIRES