Filter
Top Products
1. Mark wall with the template, using a
stud finder to maintain a 2” distance from
any stud. Make sure that you are clear of
any crossbraces in the wall structure.
FOR STANDARD
INSTALLATION
DRYWALL
THICKNESS CANNOT
EXCEED 1.25 INCHES.
FOR THICKER
WALLS CALL
M&K SOUND.
2. Cut opening precisely with a drywall
saw, drywall router, etc. Sand edges and
clean debris from installation area.
3. Fill in the wall space around the
speaker using the included foam strip.
The foam strip has 1” deep slits to allow
bending it into a 4-sided frame.
CAUTION: Be careful when bending
and handling the strip so that you do
not rip it.
4. Tape speaker wire to the back wall so
the end is within the opening as shown.
5. Fold the first section of the foam strip
and insert the corner through the wall
opening.
6. Continue folding and inserting the rest
of the foam strip into the wall opening
until the foam frame is created.
7. Make sure that the frame is centered
within the opening.
8. Mount the adhesive backed foam pad
in the wall to the left of the cutout. This
should place the foam behind the
woofers.
Note: Do not put any other acoustic filler
within the wall opening as it can interfere
with the speaker mounting.
speake
r
wire
speaker wire
!
!
IMPORTANT! - MAKE SURE WALL ELECTRICITY IS
TURNED OFF BEFORE STARTING INSTALLATION
In-wall Operation Manual
5
4. POST CONSTRUCTION INSTALLATION
wall opening
foam pad