MK Sound MX-1000 Speaker User Manual


 
page 5powered subwoofers
Look at the back panel of the Subwoofer. You will see two RCA input jacks labelled "FROM
PREAMP," and two sets of speaker wire input terminals labelled "FROM AMPLIFIER" and "TO
SPEAKERS." You must choose to use either the speaker wire inputs or the RCA jack inputs.
STANDARD AMPLIFIER/SPEAKER WIRE CONNECTIONS
The most common way to hook up the Subwoofer is to connect it to your receiver or amplifier using
speaker wires. You make the same kind of connections that you would use for your Satellite (or main)
speakers, except that both the left and right channels go to the Subwoofer. (If you are using two
Subwoofers, connect one channel only to each Subwoofer).
1. Run speaker wire between the Amplifier's Left channel output terminals and the
Subwoofer's Left channel "FROM AMPLIFIER" terminals.
a. Connect the Amplifier's Left channel Positive (+) terminal and the Subwoofer's
Left RED (+) "FROM AMPLIFIER" terminal.
b. Connect the Amplifier's Left channel Negative ( — ) terminal and the Subwoofer's
Left BLACK ( — ) "FROM AMPLIFIER" terminal.
2. Make matching connections for the Right channel. See Figure 1.
FIGURE 1 - TO AN AMPLIFIER USING SPEAKER WIRES
IMPORTANT NOTE FOR SURROUND SOUND SYSTEMS:
When the Subwoofer is connected to the Left and Right amplifier outputs, and the controller is in
Pro-Logic mode, the Center channel WIDE/NORMAL switch MUST be set to the NORMAL mode. If
the switch is set to the WIDE mode, the bass content of the Center channel will not be fed to the
Subwoofer, and you will lose a significant amount of bass.