Filter
Top Products
page 7powered subwoofers
FIGURE 2 - CONNECTING TO A STEREO AMP OR PREAMP
USING SPEAKER WIRE CONNECTIONS
Some M&K subwoofer owners hook up their Subwoofer by connecting it to their receiver or amplifier using
speaker wires. To do so, you make the same kind of connections that you would use for your Satellite (or main)
speakers, except that both the left and right channels go to the Subwoofer. (If you are using two Subwoofers,
connect one channel only to each Subwoofer).
1. Run speaker wire between the Amplifier's Left channel output terminals and the
Subwoofer's Left channel "FROM AMPLIFIER" terminals.
a. Connect the Amplifier's Left channel Positive (+) terminal and the Subwoofer's
Left RED (+) "FROM AMPLIFIER" terminal.
b. Connect the Amplifier's Left channel Negative ( — ) terminal and the Subwoofer's
Left BLACK ( — ) "FROM AMPLIFIER" terminal.
2. Make matching connections for the Right channel. See Figure 3.
100
PHASE
10391 Jefferson Blvd, Culver City, CA 90232 310/204-2854 www.mksound.com
MILLER & KREISEL SOUND CORPORATION
RIGHT
INPUT
LOW PASS FILTER
(Hz)
FROM AMPLIFIER
50
75
60
125
T
2 AMP
120 VAC 50/60 Hz
RIGHT LEFT
LEFT/MONO
SLOW-BLOW
ATTENTION:
DEBRANCHER AVANT DE
REMPLACER LE FUSIBLE.
UTILIZER UN FUSIBLE
DE RECHANGE DE MEME TYPE.
CAUTION:
DISCONNECT SUPPLY CORD
BEFORE CHANGING FUSE.
REPLACE FUSE ONLY
WITH SAME TYPE.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
AVIS:
RISQUE DE CHOC ELECTRIQUE. NE PAS OUVRIR.
+
-
BASS LEVEL
+3 dB
+6 dB
- 3 dB
- 6 dB
REFERENCE
+9 dB
BYPASS
VARIABLE
!
SURROUND PROCESSOR OR RECEIVER
+
+
MAIN INPUT
LEFT RIGHT
- LEFT +
- RIGHT +
MAIN PRE OUT
LEFT
RIGHT
MAIN SPEAKERS