Filter
Top Products
K-SERIES SATELLITE SPEAKER
Wall Mounting Bracket Template and Instructions
OUTLINE OF SPEAKER CABINET
LEVEL TEMPLATE TO THIS LINE
3/4"
7/8"
CENTER OF CABINET AND WALL STUD
WALL BRACKET
MOUNTED UP
DRILL 3/32" PILOT HOLES HERE
(FOR WALL ANCHORS, DRILL 1/8" HOLES)
1. If possible, we recommend mounting the wall bracket to a wall stud. If you are using a stud, locate the center of the stud.
2. Place this template on the wall and using a carpenter's level adjust the template until the top line is level. If you are mounting
the bracket to a wall stud, line up the bracket holes with the center of the stud.
3. Tape this template to the wall, on all four corners and recheck to make sure it is still level.
Readjust the template if necessary.
4. If you are mounting the bracket to a wood stud, drill two 3/32" pilot holes.
5. If you are mounting the bracket with the plastic anchors, drill two 1/8" holes per bracket.
(Use the plastic anchors only if you are not able to mount the bracket to a wall stud.)
6. Drill the pilot holes right through this paper template.
7. Carefully remove the template from the wall.
8. Position the bracket over the pilot holes and secure in place using the supplied wood screws.
9. If you mounting the bracket to the dry wall, insert the plastic wall anchors into the 1/8" pilot holes and drive the anchor into
place using a Philips screwdriver until they are flush with the wall.
10. Using the supplied #6 x1-3/4" screws, mount the bracket to the wall. Be careful not to force the plastic anchors through the
wall or over tighten the screws.
11. Attach the speaker wires to the speaker.
12. Place the back of the speaker (with the other component of the bracket in place) and carefully slide the speaker down the wall
until the brackets mate.
1515