Filter
Top Products
Setting up the mono power amplifier
8
Unpacking
The 505 Mono Power Amplifier comes in a box containing the
following components:
❍ 505 Mono Power Amplifier.
❍ 1 power cord.
❍ 1 phono shorting plug.
❍ This manual.
You are advised to retain the packing in case you need to
transport the unit.
Before connecting power
Before you begin installation you should ensure that your mono
power amplifier is set to the correct voltage for your local AC
supply. If it is not, do not try to install the unit, and contact your
dealer.
Do not make connections, or insert or remove plugs, while
the unit is connected to the supply and switched on, as the
transients generated could damage the loudspeaker.
Once set up, the mono power amplifier can be left switched on
as it consumes negligible power when not in use.
If you are not going to use the mono power amplifier for a period
of several days you should switch the unit completely off, at the
back panel, and disconnect it from the AC power supply.
To position the mono power amplifier
During normal operation the heatsinks, ie the fins at each end of
the case, may become quite hot. The mono power amplifier
should therefore be positioned to allow a free flow of air around
the fins.
Do not place the mono power amplifier:
❍ On a surface that may be scorched by the heat generated;
eg a carpet.
❍ In direct sunlight.
❍ Near heat sources, eg a radiator.
❍ Stacked with any other audio products, as the heat it
generates may damage the other products.