Filter
Top Products
Setting up the CD player
22
To connect to Meridian 600 or 200
Series equipment
If your system includes any Meridian 600 or 200 Series units,
with 600 COMMS or 200 COMMS sockets, you should set all
the 500 Series units to 200 COMMS operation using the
following procedure:
● Turn off the CD player, using the power switch on the back
panel.
● Turn on the power again while holding down the Off key on
the front panel.
The display will show the current
setup:
Type 1
Press ] (Next) on the front panel
to change to Type 2:
Type 2
● Switch the power off and on again to restore the CD player to
normal operation.
● To return to 500 COMMS operation repeat the above
procedure, and select Type 1.
To connect to DSP6000 or DSP5000
Digital Loudspeakers
● Connect the socket marked DIGITAL OUTPUT on the back
panel of the CD player to the M-lead, supplied with the
DSP6000 or DSP5000 speakers.
● Follow the instructions provided in the DSP6000 or DSP5000
manual for connecting to a CD player.
The DSP6000 and DSP5000 loudspeakers are fully
programmable, and you should consult your manual before
deciding which input to use. If you have any doubts, your dealer
will be able to assist you.
Suitable cables are available from your Meridian dealer, or
Meridian Audio Limited.