Filter
Top Products
4
RADIO OPERATION
Slide the FUNCTION switch to
the RADIO position.
1
Rotate the TUNING control to
select a station.
3
Slide the BAND switch to select
AM, FM or FM STEREO. Noise
present in FM broadcasts can be
reduced by sliding the BAND
switch to FM STEREO position;
the broadcast will then be in
mono.
2
Adjust the VOLUME control ❶ as
desired. Slide the FUNCTION
switch ❷ to the OFF position to
turn the unit off.
1
2
4
TO PLAY THE RADIO
PREPARATION FOR USE
AC Operation
Unwind the AC cord and extend it to its full length. Insert the end of the AC cord into any convenient 110-
120V 60Hz household outlet.
Please note that this unit is equipped with a polarized AC plug which has
one blade wider than the other. This is a safety feature to reduce the
likelihood of electric shock. This polarized AC plug will only fit in a
polarized AC outlet. If you find that you cannot insert this plug into your
outlet, you may have an obsolete non-polarized outlet. Please do not try
to defeat this safety feature by using a non-polarized adapter or by filing
the wider blade to make it fit into your outlet. If this plug does not fit into
your outlet, you should contact a qualified licensed electrician to replace your obsolete outlet.
FM STEREO
When the BAND switch is set to the FM STEREO position and a
strong FM stereo station is broadcasting, the FM ST indicator will light.
ANTENNAS
AM – This unit has a built-in ferrite rod antenna, which provides
adequate reception in most areas. If reception is weak, turn the unit to
improve reception.
FM – If reception is weak, extend the AC cord to its full length. You
may have to vary the direction of the AC cord to find the strongest
signal for each FM station.
MTT3200 O/M.QXD 2/28/03 9:22 AM Page 4