Filter
Top Products
5
This CD player requires either two “AA” cell batteries (not included) or the
provided AC adapter.
BATTERY INSTALLATION
The battery indicator will appear in the CD display when the batteries
need replacing.
1. Open the battery compartment door on the
bottom of the unit by sliding it out and then
lifting it. To prevent the possibility of losing
the cover, it cannot be removed.
2. Insert two (2) “AA” cell batteries (not included)
according to the polarity diagram inside the
battery compartment. Alkaline batteries are
recommended for the longest playing time.
AC OPERATION
To operate the unit using AC power, connect the AC adapter (included) to
an AC outlet having 120V, 50/60Hz AC only. Plug the small end into the
DC 4.5V jack on the unit and connect the other end into the AC outlet. The
batteries are automatically disconnected when
the AC adapter is used.
CAUTION: Use only the AC adapter provided
with this unit. Using another AC adapter may
damage the unit. When not using AC power,
disconnect the AC adapter from the wall outlet
by pulling the plug (not the cord). Do not touch
the AC adapter with wet hands. Fully insert the
plug without exposing any part of the blade.
POWER SOURCES
BATTERY PRECAUTIONS
Follow these precautions when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries as indicated next to the battery
compartment. Reversed batteries may cause damage to the device.
3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with
fresh ones.
4. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury
from possible battery leakage.
5. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow
battery manufacturer’s directions.)
–
+
–
+
–
+
–
+
MD6885.O/M.QXD 1/15/02 10:07 PM Page 5
This CD player requires either two “AA” cell batteries (not included) or a AC
adapter (notincluded).
BATTERYINSTALLATION
The battery indicator ( ) will appear in the CD display when the batteries
need replacing.
ACOPERATION
CAUTIO
Tooperate theunit using ACpower,connect the ACadapter (notincluded) to
an AC outlet having 120V, 50/60Hz AC only. Plug the small end into the DC
4.5V jack on the unit and connect the other end into the AC outlet. The
batteries areautomatically disconnectedwhen theACadapter isused.
N: When not using AC power, disconnect the AC adapter from the
wall outlet by pulling the plug ( not the cord ). Do not touch the AC adapter
with wethands.Fullyinsert theplug withoutexposingany part of theblade.
DC 4.5V