Memorex MA3911MS Speaker System User Manual


  Open as PDF
of 2
 
•Insertoneendoftheaudiocable(notincluded)intotheLINEOUTjackon
your external audio unit and the other end into the Line In jack X on the rear
of this unit. To listen to the external audio unit, turn this unit on by pressing
and holding the Power button x until the indicator lights and turn on the
external unit as well. Repeatedly press the Source button y to select LINE IN
mode; the indicator will light purple. The external audio unit’s output sound
will be heard through this unit’s speaker. If you wish to listen to the Bluetooth
enabled mobile device, press the Source button y to select Audio Device
mode; the indicator will light orange (or blue if not paired).
OPTIONAL CONNECTIONS: LINE IN JACK (REAR OF UNIT)
GENERAL:
Power Source (AC) .............................................DC 5V Adapter (Center Positive)
Power Source (DC) ....................................................4“AAA”size1.5VBatteries
Speaker. .............................................................................................. 2 x 4 ohm
Output Power ........................................................................................ . 2 x 1W
Weight.. ......................................................................................................5.5 oz
Dimensions ........................................................... 4 (W) x 2.4 (D) x 2.5 (H) inches
Specifications are subject to change without notice.
For additional setup or operating assistance, or an electronic version of the
MA3911MS user guide, please visit www.memorex.com
For consumer replaceable part(s), verify part number(s) then contact our parts and
accessories fulfillment center at: 1-800-379-8439
LOCATION OF CONTROLS
1 2 3 4 5
876
source
9. Line In Jack
10. DC In 5V Jack
(AC Adapter Part No. E18-00745-01*)
11. Battery Compartment
(Battery Compartment Cover Part No. P14-00262-01*)
1. Volume – Button
2. Volume + Button
3.
Button
4. Power Button
5. SourceButton(AudioDevice/AuxIn)
6. Microphone
7. Speaker
8. Indicator(Source/Power/Pairing)
9
10 11
SPECIFICATIONS
Imation Enterprises Corp.
1 Imation Way, Oakdale, MN 55128-3414 USA
www.memorex.com
© Imation Corp.
Memorex and the Memorex logo are trademarks of Imation Corp. and its affiliates.
All other trademarks are property of their respective owners.
73952100A
TROUBLESHOOTING
SYMPTOM
No sound.
Bluetooth mode:
no sound.
CAUSE
Volume is set to minimum.
Power is not on.
Batteries are weak or dead.
Unit is in Aux mode.
Unit is not paired.
SOLUTION
Increase volume.
Press and hold the Power
button to turn the unit on.
Replace batteries.
Press the Source button to
select correct mode.
Pair unit (see the Pairing a
Bluetooth enabled Mobile
Device section).
*For consumer replaceable part(s), verify part number(s)
then contact our parts and accessories fulfillment center
at: 1-800-379-8439.
NOTE:
When the volume is at the maximum or minimum level and the Volume + v
or – u button is pressed, the purple indicator will blink. To turn off the unit,
press and hold the Power button x until the indicator turns off and a series
of beeps sound.
 previous