Filter
Top Products
10
Installation
The XRT30 High Frequency Column Section requires two
or more persons to safely handle the Column during as-
sembly and placement. Follow the instructions below for
unpacking and assembly. It is recommended that the Pro-
fessionals at your McIntosh Dealer, who are skilled in all
aspects of installation and operation, install the XRT30
Loudspeaker System and any associated audio equipment.
Unpacking the High Frequency Column
1. Remove the banding material from the shipping car-
ton. Refer to figure 10.
2. Lift off the top of the
shipping carton and set
it aside.
3. Lift up on the rear of
the Column Loud-
speaker, near the foam
packing material at
both ends. Place the entire assembly (Column, Loud-
speaker Grille and foam packing material) next to the
bottom shipping carton
on a flat surface. Refer
to figure 11.
4. Release the Loud-
speaker Grille from the
packing material by
opening the slit in the
packing material lo-
cated on the top center. Remove the Loudspeaker
Grille from the protective shipping wrap and set it
aside.
5. In a similar manner, lift out the Loudspeaker Column
and set it aside.
6. Replace the shipping carton top onto the shipping car-
ton bottom. Take the two center pieces of the just re-
moved packing material and lay it down flat onto the
top of the shipping carton.
7. Carefully remove the protective shipping bag(s) from
the Loudspeaker Column so as not to mar the Column
Finish or damage the Loudspeaker Drivers.
8. Place the Loudspeaker Column on top of the packing
material located on top of the shipping carton making
sure to align the Column Bottom End (the Glass Name
Plate end) to the end of the shipping carton. Refer to
figure 12.
Unpacking the Column Base
9. Lift and remove the bubble wrap packing material
from the base.
10. Locate and remove the bag of hardware and Allen
Wrench Tool taped to the bottom of the base.
Assembling the High Frequency Column
11. Using the supplied Allen Wrench, remove two screws
from each side of
the Column Bot-
tom. Refer to fig-
ure 14.
12. Orient the Col-
umn Base with the
Decal Arrow
pointing toward
the front of the
Loudspeaker Col-
umn. Refer to fig-
ure 15.
Figure 10
Figure 11
Remove
Two Screws
Remove
Two Screws
Figure 14
Figure 13
Fastening Pin
Gromment
Figure 12
Glass Panel
Packing
material
Packing
material