Filter
Top Products
8
How to Connect for Six Channels
Left
Front
Output
Right
Front
Output
1. Connect a cable from the Control Center Amp On to
the MCC406M ON Connector on the right side of the
amplifier.
Note: All cables should be connected to the amplifier
before connecting the DC power cables to the
battery.
2. Connect a cable from a McIntosh Control Center with
Power Guard to the MCC406M PG Connector on the
right side of the amplifier.
3. Connect cables (up to 12 AWG) from six separate
Loudspeaker Drivers to the MCC406M Power
Amplifier Channels 1, 2, 3, 4, 5 and 6 Terminals, being
careful to observe the correct polarities.
4. Connect a cable (up to 12 AWG) from the Subwoofer
Loudspeaker Driver to the McIntosh Mono Power Am-
plifier Output Terminals, being careful to observe the
correct polarities.
5. Connect audio cables from the Control Center Front
Outputs to the McIntosh Electronic Crossover Inputs 1
and 2.
6. Connect audio cables from the McIntosh Electronic
Crossover Low, Mid and High Outputs 1 and 2 to the
MCC406M Power Amplifier Inputs 1, 2, 3, 4, 5 and 6.
7. Connect an audio cable from the McIntosh Electronic
Crossover Sub Output to the McIntosh Mono Power
Amplifier Input.
8. Connect the MCC406M to the vehicle battery termi-
nals using size 4 AWG (Maximum) cables.
Note: It is advisable to place an in-line fuse of a suitable
size as close as possible to the battery.
McIntosh Electronic Crossover
Power
Guard
Amp
ON
Vehicle
Battery
+-
Fuse