Filter
Top Products
MB QUART IN-CEILING / IN-WALL SPEAKER INSTALLATION INSTRUCTIONS
Thank you for purchasing the MB QUART In-Ceiling / In-Wall speaker system.
To ensure proper installation and operation of the speakers, please follow the manual carefully
and thoroughly.
- Be sure to follow the directions carefully and in the order provided below.
- Do not discard the manual. You will need this for future removal and installation.
- Be sure to adhere to all of the safety and caution tips through out the manual.
- Do not install or operate the speakers near water.
- During the installation, be sure to avoid in-wall and in-ceiling heater/AC ducts, electrical
power lines, plumbing and fire retardant insulation.
- Avoid direct exposure to heat producing sources such as heat ducts, and exhaust vents.
- Do not alter the physical elements of the assembly such as the enclosure, speaker grille or
electrical contact points.
- Route speaker wires away from heat producing sources, moving parts and exposure to water.
- Use a clean dry cloth to clean the speakers when necessary.
- Refer all service to a qualified authorized service center.
Minimum Tool Required Material Supplied
- Wire Strippers - Grille Removal Tool
- Carpenters Level - Speaker Cut-Out Template
- # 2 Phillips Screwdriver - Paint Shield
- Flat Blade Screwdriver - Owner / Install manual
- Electronic Stud Finder
- Drywall Hand Saw
- Miniature Flat Blade Screwdriver for Point Source Speakers
SPEAKER PLACEMENT (ALX2PS / ALX3PS / ALX5.25IC / ALX6.5IC / ALX6.5IC DM / ALX8.0IC)
These speakers are designed to operate in a standard drywall or suspended acoustical panel ceiling.
The speaker enclosure allows for different mounting depths that may be encountered in different ceiling
applications.
Although the speakers sound best when the back section of the speaker is left in tact.
The back section of the speaker can be removed to lessen the over all mounting height if needed.
Some building codes may require that the back enclosure half be removed so please check with your
local building codes.
When mounting to a drywall ceiling, be sure the drywall is at least 3/8” thick.
If you are mounting the speakers to typical acoustical suspended ceiling panels, you will need to
reinforce the acoustical panel with ½” plywood to ensure the speaker does not cause the acoustical
panel to sag over time.
1. Choose mounting locations that are an equal distance left and right of the listening area as shown
in DIAGRAM 1.
2. Use the speaker cut-out template supplied to mark your speaker hole locations.
(Be sure there is clearance behind the area you have chosen for the speaker. Avoid electrical wiring,
plumbing, moving parts, air ducts and Fire Stops.
1
ALEXXA SERIES