Filter
Top Products
ADDITIONAL INSTALLATION AND OPERATIONAL INFORMATION
- If you do not have the installation cut-out template, the cut-out dimensions are also located on the
speaker label located on the side of the speaker. You can also down load the template by going to our web
site at: www.maxxsonics.com
- The speaker trim bezels and grilles can also be spray painted.
There is a paint shield located in the speaker kit to prevent from getting paint on the speaker cone.
Tip: Do not use roll-on paint because it will fill-in the holes in the grille which will dramatically effect
the sound quality.
Be sure to paint the grille separate from the speaker and do not re-install the grille until the paint
has dried.
- You may order additional parts such as Dog-Ear Clamps, Grilles, Grille removal tools by contacting
Maxxsonics at: www.maxxsonics.com
6
ALEXXA SPEAKER SPECIFICATIONS
MODEL POWER RATING IMPEDANCE CUT-OUT
ALX2PS 5 - 20 WATTS 8-Ohms / 6-Ohms nom. 3.9” / 99mm Diameter
ALX3PS 5 - 30 WATTS 8-Ohms / 6-Ohms nom. 4.35” / 111 mm Diameter
ALX5.25IC 80 WATTS 8-Ohms / 6-Ohms nom. 8.9” / 227mm Diameter
ALX6.5IC 100 WATTS 8-Ohms / 6-Ohms nom 10.25” / 260mm Diameter
ALX6.5IC DM 100 WATTS 4+4-Ohms / 3+3-Ohms nom. 10.25” / 260mm Diameter
ALX8.0IC 120 WATTS 8-Ohms / 6-Ohms nom. 12.4” / 315mm Diameter
ALX5.25IW 80 WATTS 8-Ohms / 6-Ohms nom. W: 7.26” / 184.5mm x L: 14.1” / 358mm
ALX6.5IW 100 WATTS 8-Ohms / 6-Ohms nom. W: 7.9” / 200.5mm x L: 14.1” / 358mm
ALX8.0IW 120 WATTS 8-Ohms / 6-Ohms nom. W: 10.3” / 262mm x L: 20.2” / 513mm
FEATURES SUBJECT TO CHANGE WITH OUT NOTICE
-
Angled Baffle Adjustment
The Alexxa series speaker feature an angled baffle
design which positions the speaker on a 30% angle
to the speaker enclosure. This allows you to rotate the
speaker enclosure so that the speaker cone is facing
towards the listening area as shown on Diagram 4.
This is ideal for cathedral or pitched ceilings or walls
do not permit the ideal mounting locations.
Or Or
Tweeter Angle Adjustment
The tweeter element can be swivelled to allow
you to aim or point the tweeter towards the
listening area as shown above. In the event
the mid bass speaker can not be aimed towards
Tweeter Element
Or
Or
Tweeter Angle Adjustment
The tweeter element can be swivelled to allow
you to aim or point the tweeter towards the
listening area as shown above. In the event
the mid bass speaker can not be aimed towards
Mid Range Speaker
Mid Range Speaker
In-Wall Speaker
In-Ceiling
Speaker