Filter
Top Products
POWER INPUT
SPEAKER OUTPUT
- - + +GND REM +12V
FUSE
L
R
L
R
9V 0.2V 0 180 0dB 10dB 15 35Hz 35 250Hz PRO
INPUT OUTPUT BALANCED LEVEL PHASE REMOTE BASS EQ SUBSONIC LOW PASS PWR
INPUT
8
TXi1008D / TXi1508D / D CLASS 1 CHANNEL AMPLIFIER APPLICATIONS
Basic application
Interconnect cable checklist: Minimum final loudspeaker impedance:
- Connect the line inputs to a Radio/CD RCA outputs or line output of the - 1 ohm.
full range primary amplifier with good quality RCA cables. A “Y” adapter
may be needed as shown in the diagram.
- Use at least #12 gauge speaker wiring. These amplifiers have dual
speaker terminals, simplifying the hookup of multiple speakers
Crossover frequency control checklist:
- LOW PASS: 35Hz to 250Hz
- SUBSONIC:15 Hz to 35 Hz
- BASS EQ: 0 to 10dB
- PHASE: 0 to 180 degrees
Level control checklist:
- Refer to the section “Setting up systems after installation for best
performance”
FULL RANGE
STEREO LINE INPUT
NOT USED
Y-ADAPTOR
Note: You can use the Radio/CD designated mono line output
or a full range stereo line output. For full range stereo line output,
you will need an optional “Y-Adaptor” as shown
*
Dual Subwoofer Application
PARALLEL MONO
SUBWOOFERS
2-OHMS EACH MINIMUM
MONO
SUBWOOFERS
POWER INPUT
SPEAKER OUTPUT
- - + +GND REM +12V
FUSE
L
R
L
R
9V 0.2V 0 180 0dB 10dB 15 35Hz 35 250Hz PRO
INPUT OUTPUT BALANCED LEVEL PHASE REMOTE BASS EQ SUBSONIC LOW PASS PWR
INPUT
MONO
SUBWOOFER
STEREO LINE
OUTPUT
STEREO LINE
OUTPUT
DESIGNATED
MONO LINE INPUT
DESIGNATED
MONO LINE INPUT
*
*
REMOTE TURN-ON
REMOTE TURN-ON
CHASSIS GROUND
CHASSIS GROUND
TO BATTERY +12v
VIA FUSE
TO BATTERY +12v
VIA FUSE