Filter
Top Products
MAXX-LINK MLX-100 BRIDGING MODULE FEATURE DESCRIPTIONS
MASTER OUT / SLAVE IN: The Master Out sends master signal to another MLX-100.
The Slave In receives a Master signal and all controls are bypassed on the unit.
BR-1 REMOTE CONTROL: Using an Rj45 cable, the BR-1 Bass Remote Module plugs
directly into the MLX-100 and allows you to adjust the Level from -20dB to 0 dB as well
as Normal and Bypass operations.
NORMAL: BR-1 is fully adjustable from -20dB to 0dB.
BYBASS: BR-1 is set to 0dB fixed regardless of where the dial is set.
LINE INPUT: Accepts unbalanced RCA inputs from 0.2 volts to 9 volts.
LINE OUTPUT: The unbalanced RCA outputs are Left and Right Full Range outputs.
BRIDGING OUTPUTS: A+/- through E+/- provide signal output to up to 10 linked mono
block amplifiers.
MASTER/ SLAVE MODE: Should be set in Master position when controlling amplifiers
and Slave position when it is being controlled by another MLX-100.
LOW PASS FILTER: The Low Pass Filter is fully adjustable from 35Hz to 250Hz at
24dB per Octave.
SYSTEM DIAGNOSTICS: The MLX-100 has built-in monitoring devices. The light
turns RED when the signal is Clipped and Green when it is 9 volts.
OUTPUT LEVEL: Fully adjustable signal output to amplifiers from 1 volt to 9 volts.
TEST TONE: Selectable OFF/ON 65Hz Test Tone provides a constant tone for testing
and tuning the output level on the amplifiers.
SUBSONIC FILTER: The Subsonic Filter is fully adjustable from 15Hz to 35Hz at 24dB
per Octave.
INPUT LEVEL: The Input Level (gain) control allows you to match the MLX-100 input
sensitivity to the Output Level of the source from 9 volts to 0.2 volts.
PHASE: The Phase Shift is fully adjustable from 0 to 180 degrees.
PARAMETRIC BASS EQ:
BOOST: The Bass Boost is fully adjustable from 0dB to 10dB.
BANDWIDTH: The Bandwidth is fully adjustable from narrow to wide.
FREQUENCY: The Frequency is fully adjustable from 30Hz to 100Hz.
END PANEL CONNECTIONS
TOP MOUNT CONTROLS
1