Filter
Top Products
We know that you are eager to hear your new Dynamo sub-
woofer, so this section is provided to allow fast and easy
set
up. Once you have it operational, please take the time to
read, in depth, the rest of the information in this manual.
It will give you perspective on how to attain the greatest
possible performance from this most exacting woofer system.
If you experience any difficulties in setup or operation of the
Dynamo, please refer to the Placement, Room Acoustics
and Connections and Control Settings sections.
Should you encounter a persistent problem that cannot
be resolved, please contact your authorized MartinLogan
dealer. They will provide you with the appropriate technical
analysis to alleviate the situation.
WARNING!
• Hazardous voltages exist inside—do not
remove cover.
• Refer servicing to a qualified technician.
• To prevent fire or shock hazard, do not
expose this module to moisture.
• Unplug subwoofer should any abnormal
conditions occur.
• Use only with a grounded outlet.
Step 1: Unpacking
Remove your new Dynamo subwoofer from its packing.
Please note, Dynamo's grill cover should not be used
in the standard down firing configuration. The grill
cover is supplied for use while the Dynamo is ori-
entated in the optional front firing configuration
(see page 14).
Step 2: Placement
Ideally, place the Dynamo in a corner near the front of the
room. This is a good place to start. Please see the Placement
section (page 13) of this manual for more details.
Step 3: Signal Connection
Use the best cables you can. High quality cables, available
from your specialty dealer, are recommended and will
give you superior performance.
Attach your preamplifier/processor outputs through cables
to the signal input area located on the Dynamo’s rear
panel. Please see the Connections and Control Settings
section (pages 6–12) of this manual for more details.
If you plan to connect your Dynamo using speaker level
(high level) inputs, please refer to the 2-Channel Mode
Using Speaker Level Inputs section (page 9) of this manual
for more details.
Step 4: Power Connection (AC) (see warning)
Make sure the level knob is set at 0. Plug the Dynamo
subwoofer into a wall outlet. Review the AC Power Connection
section (page 12) of this manual for more details.
Step 5: Setting the Controls
Set the level knob to a medium volume position (12 o'clock).
Set the power switch to ‘Auto’.
Step 6: Listen and Enjoy
Now, you may adjust your system and enjoy!
3Installation in Brief 3
INSTALLATION IN BRIEF
The lightning bolt flash with arrowhead symbol within
an equilateral triangle is intended to alert the user to the
presence of uninsulated “dangerous voltage” within the
product’s enclosure that may be of sufficient magnitude
to constitute a risk of electric shock.
The exclamation point within an equilateral triangle is
intended to alert the user to the presence of important
operating and maintenance (servicing) instructions in
the literature accompanying the appliance.