Filter
Top Products
WARNING! These instructions are written
based on commonly available IR repeaters that
mount in a
1
/2" diameter hole. Before beginning
this installation, please refer to the instructions
that came with your IR repeater to verify this
hole size. If your IR repeater requires a hole size
other than
1
/2" diameter, adjust these instruc-
tions accordingly. Before drilling the mounting
hole, a
1
/8" pilot hole should always be drilled
from the back regardless of the final mounting
hole diameter.
Required tools (not inc
luded):
Electric drill
1
/8" drill bit
1
/2" drill bit
1 Prepare a flat surface with a cushion and/or blanket to
protect the Voyage. Place the Voyage driver side down.
WARNING! Be careful to put no weight on
the tweeter globe.
2 From the rear of the speaker and at the location shown
in figure 13, use a
1
/8" drill bit to drill a pilot hole.
3 Turn the Voyage over so that it is driver side up.
4 From the front of the speaker, use a
1
/2" drill bit to
widen the hole for the IR repeater.
5 Follow the instructions that come with the IR repeater to
finish installation.
INSTALLING AN IR REPEATER
Figure 13. Installing an IR repeater—location to drill hole.
Installing an IR Repeater 9