Filter
Top Products
4
BREAK IN
Allow approximately 72 hours of break-in at 90
dB (moderate listening levels) before any critical
listening.
INSTALLING ON A FLAT SURFACE
If you have a surface that provides a wide, level,
and stable platform, the speaker can be placed
directly on top. When using the speaker in this
configuration, affix the pads to the bottom of the
speaker at the rear contact points. Note:.This
speaker is not magnetically shielded and therefore
should not be placed directly beside or atop a
CRT television.
REMOVING THE LOGO BADGE
To remove the logo badge unbend the tab on the
back side of the logo then gently pull it away from
the speaker grill (fig. 8).
ConneCtion
WARNING! Turn your amplifier
off before making or breaking any
signal connections!
These speakers are designed with easy-to-use
push-style binding posts that accept bare wire or
pins (fig. 2). Additionally, by removing the rubber
inserts, they will accept banana plugs (fig. 3)
Assign the same color to the (+) and (–) terminals
on both the speaker and the amplifier. Make certain
that all connections are tight.
Fig. 1
installation
WARNING! Installation other
than that described in the body of
this document requires specific
documentation from MartinLogan.
Fig. 2 Fig. 3
Fig. 4