Filter
Top Products
10 Connections and Control Settings
AC Power Connection
WARNING! The power cord should not
be installed, removed, or left detached from
the subwoofer while the other end is con-
nected to an AC power source.
The IEC power cord should be firmly inserted into the AC
power receptacle on the rear connection panel of the
Dynamo, then to any convenient AC wall outlet. The Dynamo
also integrates a signal sensing power supply that automati-
cally switches off after sensing no music signal for several
minutes (this will occur when the power switch is set to 'Auto').
Your Dynamo subwoofer is wired for the power service
supplied in the country of original consumer sale. The AC
power rating applicable to a particular unit is specified
both on the packing carton and on the serial number plate
attached to the subwoofer.
If you remove your Dynamo subwoofer from the country of
original sale, be certain that AC power supplied in any
subsequent location is suitable before connecting and oper-
ating the subwoofer. Substantially impaired performance
or severe damage may occur to the Dynamo subwoofer if
operation is attempted from an incorrect AC power source.
Replacing the Fuse
If the fuse in your Dynamo 1000 should require changing,
turn off and unplug your Dynamo 1000 before removing
the fuse. Replace the bad fuse with a matching T 5A L
250V (T 2.5A L 250V if you are in a region using 230V).
Break-In
Our custom made woofers require approximately 50 hours
of break-in at moderate listening levels before their optimal
performance occurs. This will factor in on any critical listen-
ing and judgment.
Optional Wireless Connection
The Dynamo 1000 incorporates a wireless receiver for
use with the MartinLogan SWT-1 Subwoofer Wireless
Transmitter (sold separately and available from your autho-
rized dealer or the Xtatic shop at www.MartinLogan.com).
To establish a wireless connection, connect a transmitter to
your electronics and follow these two easy steps.
1. Press the Dynamo 1000’s sync button once. The LED
will blink quickly.
2 Press the sync button on the SWT-1 transmitter once.
The LED will blink quickly. If pairing has completed suc-
cessfully both LEDs will stop blinking and remain on.
Please note: If a link is not established after 10
seconds this transmitter’s LED will start blinking slowly.
Repeat both steps.
WARNING! When operating wirelessly this subwoofer
may be susceptible to RF interference in the 2.4GHz
bandwidth from microwave ovens and wireless devices
such as WiFi systems, video game consoles, cordless
telephones, blue tooth devices, and baby monitors.
Generally, this issue (popping noises) is easily resolved
by physically separating problematic devices from one
another—adistanceaslittleastwofeetwilloftenalleviate
the interference. In the case of microwave ovens, the inter-
ference will only occur when the microwave is operating.
Figure 6. Establishing a connection between the Dynamo 1000 and the
SWT-1 Subwoofer Wireless Transmitter (sold separately).