Filter
Top Products
5. Overdrive VOLUME control
Amazingly enough, this control adjusts the
volume of the Overdrive channel! The louder
this channel is set, the ‘looser’ the amplifier will
sound and feel. This behaviour is exactly what
a good all-valve amplifier does and is a result
of our proprietary FDD circuitry.
6. EQ BASS control
This control affects the bass or bottom end of
your sound. Increasing the bass control will add
warmth to your clean and balls to your
overdrive tones.
7. EQ CONTOUR control
This highly effective tone control works by
radically modifying the mid-range (body). The
tone can range from traditional and woody
sounding (setting at 10), to balls-to-the-wall
(setting at midway), to aggressive, ‘scooped’
and modern (setting at 0)…and all points in-
between.
8. EQ TREBLE control
This control affects the treble or top end of
your sound. Increasing the amount of treble will
give a glassy edge to your clean sounds and
increase the definition on low gain overdrive or
the amount of aggressive ‘fizz’ and ‘cut’ on high
gain tones.
9. FDD (Frequency Dependant
Damping) Switch
Marshall’s proprietary FDD circuit accurately
mimics the way an all-valve amplifier interacts
with the loudspeaker and adds a width and
depth to your sound which has been
unachievable in an affordable solid-state
amplifier…until now!
10. CD IN & EMULATED LINE OUT
jack
The MG15’s cleverly combine the Line Out
and CD Input functions. If you want to jam to
your favourite CD or tape, merely connect the
headphone output of your CD or tape player
here, adjust the CD / TAPE player’s volume to
match that of your guitar and ‘hey-presto’ –
you’ve got the perfect ‘play-along’ practice
system. Alternatively, you can use this socket
to connect the MG15 to your multi-track
recording machine and you’ll get a great
speaker emulated guitar sound direct to disk or
tape.
HELPFUL HINT: for ‘silent’ recording merely
plug an unconnected jack plug into the
headphone socket and you’ll disconnect the
MG15’s internal speaker.
11. EMULATED HEADPHONES jack
Plug your headphones here for a killer
speaker emulated sound! Doing this mutes
your MG15’s internal speaker for ‘silent’
practice.
12. POWER Switch & LED
The power switch turns your amplifier on and
off. The LED will be lit when your amplifier is on
and will not be lit when the amplifier is switched
off.
Note: Before connecting to the mains
electricity supply, always ensure that your
electricity supply is compatible with your
amplifier, as detailed on the rear panel.
Please ensure the amplifier is switched off
and unplugged from the mains electricity
supply before being moved.
13. Reverb LEVEL control
(MG15CDR only)
Increasing the Reverb Level control will mix
more of the naturally voiced spring reverb
signal into your sound – as you’ll find, you can
go from subtle to surf at the mere twist of this
control!
4
ENGLISH
MG15 Hbk multi 230V 1/3/02 9:55 am Page 4