Filter
Top Products
WARNING! - Important safety instructions
WARNING: This apparatus must be earthed!
A PLEASE read this instruction manual carefully before switching on.
B ALWAYS use the supplied mains lead, if a replacement is required please contact your
authorised Marshall Dealer.
Note: Closed back equipment with non-detachable mains cord.
When the equipment is not in use or is being transported, the mains
cord should be gathered and retained under the top strap handle to
prevent damage. See diagram.
CNEVER attempt to by-pass the fuses or fit ones of the incorrect value.
D DO NOT attempt to remove the amplifier chassis, there are no user serviceable parts.
E Refer all servicing to qualified service personnel.
Servicing is required when the apparatus has been damaged in any way, such as when the
power supply cord or plug is damaged, liquid has been spilled or objects have fallen into the
apparatus, the apparatus has been exposed to rain or moisture, does not operate normally
or has been dropped.
FNEVER use an amplifier in damp or wet conditions.
G ALWAYS unplug this apparatus during lightning storms or when unused for long periods of
time.
H PROTECT the power cord from being walked on or pinched particularly at plugs,
convenience receptacles and at the point where they exit from the apparatus.
I DO NOT switch the amplifier on without the loudspeaker connected.
➲
Note: This equipment has been tested and found to comply with the requirements of the EMC
directive (Environments E1, E2 and E3 EN 55103-1/2) and the Low Voltage directive in the E.U.
➲
EUROPE ONLY - Note: The Peak Inrush current for the MG10CD is 2 amps.
➲
CAUTION: Any changes or modifications not expressly approved by the party responsible for
compliance may void the users authority to operate the equipment.
➲
Note: It is recommended that all audio cables used to connect to the MG10CD are of a high
quality screened type. These should not exceed 10 metres in length.
➲ WARNING:
Always ensure free movement of air around the amplifier!
USA ONLY - DO NOT defeat the purpose of the polarised or grounding type plug. A
polarised plug has two blades with one wider than the other. A grounding type plug has two
blades and a third grounding prong. The wide blade or the third prong are provided for your safety.
When the provided plug does not fit into your outlet, consult an electrician for replacement of the
obsolete outlet.
Follow all instructions and heed all warnings
KEEP THESE INSTRUCTIONS !
2
!
ENGLISH
MG10CD Hbk Multi 230V 25/2/02 4:31 pm Page 2