Filter
Top Products
This allows you to operate your equipment (VCR, DVD player, etc) with your original remote or
the remote supplied from the location where the CableLink Receiver is used (e.g. at your
remote TV). The antenna must be placed in an upward position.
2. A/V Output: Connect this output with your remote TV (or VCR) by means the supplied RCA
cable and the scart adaptor.
3. Channel Selector: Channel Selector: To set the 2,4GHz channel. Setting of Transmitter and
Receiver should be same (A,B,C or D).
4. Power input: The supplied mains adaptor is connected to this input jack.
5. Power switch: This is for switching the receiver on and off. When switched on, no indicator
lights up.
6. 2,4 GHz Antenna. Receives the audio/video signals from the transmitter.
7. IR Window: Point your remote to this window to transmit IR commands to the equipment
connected to your CableLink Receiver.
5.Installation of the system.
5.1 Installation of the transmitter without extra A/V equipment (Antenna only).
1. Connect the coaxial cable supplied [C] to your antenna wall socket.
2. Connect the coaxial cable to the Antenna Input [] of your CableLink Transmitter.
3. Select a channel with the Channel Selector [9] e.g. C.
4. Connect the powersupply [6]
5. Switch on the power [7]
6. Place the Transmitter on an convenient location, and direct the flat 2,4 GHz antenna [K] in the
direction of the Receiver location.
5CABLELINK
TV
SCART
RADIO TV
3
C
A