Filter
Top Products
Nº33H Monaural Power Amplifier
Rated power output: 150W/ch continuous rms power @ 8Ω
300W/ch continuous rms power @ 4Ω
The above power ratings measured as continuous (rms) power
from 20Hz–20kHz with no more than 0.3% THD (assuming that the AC mains can
deliver adequate current, without its own voltage sagging)
Frequency response: within 0.2dB from 20Hz to 20kHz
Signal-to-noise ratio
(main outputs): better than –80dB (ref. 1W)
Voltage gain: 26.8dB
Input impedance: 100kΩ (balanced)
50kΩ (single-ended)
Input sensitivity: 1.59V for full rated output
Output impedance: less than 0.05Ω from 20Hz–20kHz
Power consumption: typically 540 watts (±5%) at idle
typically 210 watts (±5%) in standby
Mains voltage: 100V, 120V, 220V, 230V, or 240V at either 50 or 60Hz, factory set for destination country
Connector complement: (2) pairs custom binding posts
(1) balanced input on XLR
(1) single-ended input on Mark Levinson RCA
(1)
3.5mm trigger out jack
(1)
3.5mm trigger in jack
(1)
RJ-45 communications por
t (Mark Levinson Linking
™
)
(1)
RJ-11 communications por
t (Mark Levinson Linking
™
)
(1)
captive high cur
r
ent AC mains cor
d
Overall dimensions: width:
11"
(27.94cm)
height:
18.5"
(47cm)
depth:
22.875"
(58.1cm)
Shipping weight: 220lb (100kg) each
Specifications ar
e subject to change without notice.