Filter
Top Products
Input and output connectors Two balanced XLR inputs
Two unbalanced RCA inputs
Two “Hurricane” loudspeaker outputs with
banana-plug sockets (banana-plug sockets
not available on the 230V AC models)
Control connectors Two Link2 ports
One Ethernet port
One 3.5mm mono (tip/sleeve) mini plug
trigger input, 3V–12V DC
One 3.5mm mono (tip/sleeve) mini plug
trigger output, 3V–12V DC
3-Pin IEC standard power connector
Rated output power 20Hz to 20kHz at <0.5% THD, 400W per
channel @ 8Ω, full output from 2.59Vrms
Frequency response Within 0.1dB from 10Hz to 20kHz
Signal-to-noise ratio >85dB, reference level: 2.83Vrms
Input impedance 100 kΩ (balanced); 50 kΩ (unbalanced)
Voltage gain 26.8dB
Input sensitivity 2.83Vrms output at 130mVrms input
Output impedance <20 mΩ, 20Hz to 20kHz
Power requirements 100V~, 120V~, 230V~, 800W, factory-set
for destination country
Dimensions Height (with feet): 9-9/16¨ (243mm)
Height (without feet): 8-3/4¨ (222mm)
Width: 17-1/2¨ (445mm)
Depth: 21-1/8¨ (536mm)
Weight Net weight: 121.5 lb (55.2kg)
Shipping weight: 129.5 lb (58.8kg)
Operating environment Operating temperature: 0º to 35ºC (32º to 95ºF)
Storage temperature: –30º to 75ºC (–22º to 167ºF)
Relative humidity: 95% maximum
without condensation
N
o
532 Dual-Mono Power Amplifier
Each amplifier channel utilizes two current-gain (CG) boards for the
balanced output drivers. The CG boards are made from Arlon 25N,
which was chosen for its superior dielectric characteristics.
HSG1001_ML-532Lit 9/16/08 9:16 AM Page 7