Mark Levinson N436 Stereo Amplifier User Manual


 
3 Oak P
ar
k, Bedford, MA 01730-1413 USA
T
el:
781-280-0300 | Fax: 781-280-0490
www
.mar
kle
vinson.com
Specifica
tions are subject to change without notice.
Mark Levinson
®
is a registered trademark of
Harman International Industries, Incorporated.
Not responsible for typographic errors.
Part # 072-16385
Nº436/434 MonoPowerAmplifiers
Rated power output: Nº436
350W/ch continuous rms power @ 8
700W/ch continuous rms power @ 4
Nº434
125W/ch continuous r
ms power @ 8
250W/ch continuous r
ms power @ 4
all above power ratings measur
ed as continuous (rms) power from 20Hz–20kHz with no more than
0.5% THD (assuming that the AC mains can deliver adequate cur
rent, without its own voltage sagging)
Fr
equency response:
within 0.3dB fr
om 20Hz to 20kHz
Signal-to-noise ratio
(main outputs): better than –80dB (r
ef. 1W, 8)
V
oltage gain:
26.8dB
Input impedance: 100k
(balanced)
50k
(single-ended)
Input sensitivity: Nº436
2.42V for full rated output
Nº434
1.44V for full rated output
Output impedance: less than 0.05
from 20Hz to 20kHz
Power consumption: Nº436
typically 525 watts (±5%) on
typically 100 watts (±5%) in standby
Nº434
typically 275 watts (±5%) on
typically 100 watts (±5%) in standby
Mains voltage: 100V, 120V, 200V, 220V, or 240V at either 50 or 60Hz, factory set for destination country
Connector complement: (1) pair custom binding posts
(1) balanced input on XLR
(1) single-ended input on Madrigal RCA
(1) 3.5mm trigger out jack
(1) 3.5mm trigger in jack
(1) RJ-45 communications port (Mark Levinson Linking
)
(1) RJ-11 communications port (Mark Levinson Linking
)
(1) RS-232 communications port on RJ-11
(1) IEC-standard AC receptacle
Overall dimensions: Nº436
width: 17.75" (45.1cm)
height: 7.65" (19.4cm)
depth: 20.21" (51.3cm)
Nº434
width:
17.75"
(45.1cm)
height:
5.91"
(15.0cm)
depth:
20.21"
(51.3cm)
Shipping weight:
Nº436
95lb
(43.7kg) each
Nº434 65lb
(29.9kg) each
Specifications ar
e subject to change without notice.
Nº436